Dual Tank Cold And Heat With Light Juice Machine With CE
Konmax Cold Drink Dispenser Specification:
Model | LRSPD-18L×2 |
Voltage | 220-240V/110-115V |
Frequency | 50/60/HZ |
Cold poqer | 320W |
Heat poqer | 1500W |
Cold-beverage temperture | 7C-12C |
Hot-beverage temprture | 52C-58C |
Shape size | 510×470×740 |
Carton Packing | 530×490×760 |
Weight | 40 |
Gross weight | 42 |
Konmax Cold Drink Dispenser Detailed Photo:
Konmax Cold Drink Dispenser Packing Photo:
Konmax Cold Drink Dispenser Installing Methods and Notices
1.To install it , please choose tyhe site which is flat ,flexbile
and can avoid the direct sunshine in summer .
2.Around the machine should have 150 mm up room to make the air
circulating and make sure the machine can run effectively .
3.Before installing it please check the supply power whether it
confirms to the requirements or not , The power supply cable is not
too thin ot too long .The cross section of cable should be
1.5-2.5mm ,voltage is mouted on the fixed position with fuse which
keep the users safety it must have the reliable grounding ,
The socket should be mouted on the fixed position with fuse which
will keep the machine running safety .
4.To make the fix position for machine should make its fron lower
and back higter (to adjust the foot of the
bottom can do it ),then the water in salver can flow into the box
through the hose .
How to use the cold beverage machine?
1.To fall prepared beverage into the crock , the height of it is
should not exceed the standard height (9L-12L-18L-20L-50L),
otherwise the beverage will flow into the churn-dasher from the
dasher tube,which will make the dasher burn .
2.The temperature of the beverage should not too high (not exceed
35), otherwise it will make bad effection for the refrigeration .
3.Plug in the supply power to the 3 hole socket , the grounding
hold should connect with the protecable wire or fixture to ensure
the safety .
4.To turn the switch on the position of refrigeration , press down
the refrigeration switch , the compressor fan starts running and
refrigeration system starts working .
Then start the dasher to mix or start the spewing swtich to spew.
5.When the beverage becomes to the suitable temperature , please
make the cup against the push board lightly .the beverage will flow
into the outlet mouth .
6.when the temperture reduces to the certain degree , the
refrigeration will stop running because of the influence from the
temperaturecotroller .And when it increases, it will start
automatically again .
7.It should re-start after 5 minuters if it turn off suddenly or
stop temporarily .otherwise it will damage the compressor .
