Lux - Off Function , Microwave Motion Sensor Switch , On / Off
Control , Distinguish Natural Light And Artificial Light
Simple ON/OFF sensor for American market, 120~277V AC input.
Duall-PD daylight sensor to differently read natural light and
artificial light. Lux-Off function for built-in application.When
there is motion detected, the lamp will be switched on
automatically, and after the chosen hold-time, the lamp will be
switched off.
Features--
5.8GHz C-band microwave motion sensor, on/off control.
Operating voltage: 120〜277V AC, 60Hz.
Rated load: 200W (capacitive)
Stand-by power: <0.5w.
Dual-processor technology, real Lux-Off function for built-in
application.
Zero-cross point operation, protect the sensor relay against the
in-rush current, secure the max. load and life time of the relay.
Detection range up to 12m in diameter.
Mounting height: 3〜6m.
Operation temperature: -20℃ ~ +70℃ .
IP rating: IP20.
Settings--
Detection range
Detection range can be reduced by selecting the combination on the
DIP switches to fit precisely each application.
Hold-time
Hold-time means the time period to keep the lamp on 100% after
motion detected.
*when hold-time set as 3s, sensor enters into test mode, this test
mode is mainly for users to choose the desired detection range. In
this mode, the daylight sensor is disabled, when there is no
motion, fixture keeps off, when there is motion detected, fixture
keeps a cycle of 3s on and 2s off.
Daylight sensor
Daylight sensor means the daylight threshold to enable or disable
the sensor function.
"Disable”: The sensor works always, even during daylight.
"50lux, 25lux": The sensor works only in twilight.
"10lux, 2lux": The sensor works only in the dark.
Wiring diagram--
Detection pattern--
Lux-Off function--
Utilizing the Dual-processor technology, this sensor can tell the
difference of natural light and artificial light(lamp) from behind
the diffuser, then switch off automatically whenever the artificial
light is not required(ambient light is bright enough).
This is the REAL& INTELLIGENT lux-off sensor for built-in
installation.
Note: Lux-Off sampling time--30s
