Radiator stripper machine is designed to separate the scrap
radiator for recycling copper and aluminum with high efficiency and
stable performance. It can strip the radiator whose copper tube
center distance is 19mm, 21mm or 25mm. Before processed, the
radiators shall be cut with a band saw into pieces of certain
width. It can separate one layer or two layers radiators. When
radiators are more than two layers, it will be cut into one layer
or two layers by band saw machine.
Technical specification of radiator stripper machine
| Dimension | Capacity | Power | Weight | Motor |
| 1800*800*1200 mm | 2000-3000 kg/day | 3+4 kw | 650kg | customized |
Working Process of radiator stripper machine
1. Turn the Reversing Switch and check the rotating direction.
2. Inject oil into the two oil holes in the left and right side of
the machine to lubricate transmission gears (normally once per 4
working hours).
3. Push different radiators into different Material Inlets
according to their specs (19mm, 21mm, 25mm); the left side of
radiators must touch the left side of Material Inlets. Or the right
side of radiators must touch the right side of Material Inlets.
when radiators are pushed into Material Inlets, Feeding Gears will
gnaw at radiators and take them into the machine.
4. After radiators are taken into the machine, copper pipes and
aluminum are separated and come out of the machine automatically.
5. According to the layers of radiators and their height, adjust
each pair of Adjusting Wheels on the machine (after adjusting,
tighten screws below).
Material Preparation of radiator stripper machine
1. Iron heads of radiators must be cut off the two sides of
radiators;
2. Radiators must be cut with a band saw according to the width of
each Material Inlet;
3. Radiators that are more than 2 layers must be cut into one layer
and two layers with the band saw;
4. Do not feed radiators into wrong Material Inlets (three inlets
each are for 19mm, 21mm, 25mm radiators respective);
5. This machine is suitable for processing one layer radiators when
it is shipped to customers. When you need to process two-layer
radiators, just remove the iron covers from the Lower Blade Roller
to expose the blades.
6. When two-layer radiators are processed, the left side of the
radiators shall touch the left side of each Material Inlet, and the
first copper pipe in the Upper Layer to the left side of each
Material Inlet must be nearer than the first copper pipe in the
Lower Layer to the Left Side of each Material Inlet.
7. For both one-layer and two-layer radiators, the left side of
radiators must touch the Guiding Rulers and are radiators must be
fed into Material Inlets along the guiding rulers.
8. When radiators are fed into Material Inlets correct, each
Feeding Gear at the Material Inlet must be at the middle of each
two copper pipes; or copper pipes and aluminum will not be
separated.
9. Twisted radiators can not be processed.
