Industrial Casting Steel Diaphragm Pump 2 Inch For Printing Ink
Air Driven Double Diaphragm Pump Advantages:
- Idling ,Self-priming , Submerse capability.
- Provide stall-free, ice-free zero leak operation.
- Epoxy-coated air section for tough environmental conditions.
- Low shear force , not easy to damage the material structure.
- Bolt joint design provides even sealing pressure for optimal
performance
- Modular air valve,low pulsation operation,providing smooth and
rapid changeover.
- No electricity . It's safe and realiable while using in the flammable and explor place .
- Diversity of material,no rotating parts,applicable to various
erosive situations.
- Can pump corrosive , volatile, flammable, poisonous fluids with
particles and high viscosity.
- Delivery lift and flow can pass the pneumatic valve open to realize
the stepless adjustment.
Air Driven Double Diaphragm Pump Introduction
Air diaphragm pump(also know as a Membrane pump, air operated double diaphragm pump(AOOD) or pneumatic diaphragm pump)that uses a combination of the reciprocating action of a
rubber,thermoplastic or diaphragm and suitable valves either side
of the diaphragm (check valve,butterfly valves,flap valves,or any
other form of shut-off valves) to pump a fluid.
Air Driven Double Diaphragm Pump Parameters
| Item | Description | Unit | Reference Figure |
| 1 | Maximum air inlet pressure | Mpa | 0.83 |
| 2 | Maximum flow rate | L/Min | 192 |
| 3 | Maximum lift | M | 70 |
| 4 | Maximum outlet pressure | Mpa | 0.83 |
| 5 | Maximum particle size | mm | 3 |
| 6 | Weight | kg | 12.3 |
| 7 | Noise level | db | ＜70 |
A 2 5 X X - X X X - X (model selection)
Form of pipe mouth:A-BSP B-NPT(F) C-Flange
Diaphragm material:9 – Santoprene H – Hytrel T - PTFE/Santoprene
Ball material:9 -Santoprene H – Hytre T – PTFE A - Acetal
Ball seat material:P/K –Polypropylene/Kynoar SS –Stainless Steel
Pump material: SS –Stainless Steel AL –Aluminum Alloy CI- Carbon
Steel P/K –Polypropylene/Kynoar
Maximum Applied Temperature Limits (diaphragm / ball / seal material)
Acetal ···············································40°- 150°F
(4.4- 65.5°C)
Santoprene········································-40°- 225°F
(-40°- 107.2°C)
··················································40°- 220°F (4.4°-
104°C) Nitrile·················································10°-
180°F (-12°- 82°C)
Viton··················································-40°- 350°F
(-40°-176.6°C)
Hytrel·················································-20°-150°F
(-12°- 93°C)
Kynar··················································10°-200°F
(-28.9°- 65.5°C)
Polypropylene·······································32°- 175°F
(0-79.4°C)
1” Flow diagram
