Yaskawa Input 6.0 AMPS SERVO DRIVER 400Watt Industrial Sevro Pack SGDE-04VS

SGDE01AP 230VAC 1-PH 2.5AMP OUTPUT 100W. 0.87A
SGDE01AS 230VAC 1-PH 2.5AMP 100W. 0.87AMP
SGDE01BP SERVO DRIVE
SGDE01BPY34 SERVO DRIVE
SGDE01VP SERVO DRIVE
SGDE02AP 230VAC 1PH 4AMP OUTPUT 200W 2AMP
SGDE02APA SERVO DRIVE
SGDE02AS 200-230VAC 50/60HZ 1PH 4A
SGDE02BP SERVO DRIVE
SGDE02VP 4.0AMP 1PHASE 50/60HZ 200/230VAC
SGDE03BS SERVO DRIVE
SGDE04AP 200-230VAC 50/60HZ 6A
SGDE04AP 200-230VAC 50/60HZ 6A
SGDE04AS SERVO DRIVE
SGDE08AP SERVO DRIVE
SGDE08APY1 SERVO DRIVE
SGDE08AS SERVO DRIVE
SGDE08VP(R) SERVO DRIVE
SGDE08VPR SERVO DRIVE
SGDE08VS 11AMP 1PHASE 50/60HZ 200/230VAC
SGDEA3AP SERVO DRIVE
SGDEA3VP SERVO DRIVE
SGDEA5AP SERVO DRIVE
SGDEA5BP SERVO DRIVE
SGDEA5BS SERVO DRIVE
SGDEA5VP SERVO DRIVE

The material which we choose is good quality magnetic steel, which for historical reasons is usually referred to as ‘iron’. This brings several very dramatic and desirable beneWts, as shown in Figure 1.7.

Firstly, the reluctance of the iron paths is very much less than the air paths which they have replaced, so the total Xux produced for a given MMF is very much greater. (Strictly speaking therefore, if the MMFs
and cross-sections of the coils in Figures 1.6 and 1.7 are the same, many more Xux lines should be shown in Figure 1.7 than in Figure 1.6, but for the sake of clarity similar numbers are indicated.) Secondly, almost all the Xux is conWned within the iron, rather than spreading out into the surrounding air. We can therefore shape the iron parts of the magnetic circuit as shown in Figure 1.7 in order to guide the Xux to wherever it is
needed. And Wnally, we see that inside the iron, the Xux density remains uniform over the whole cross-section, there being so little reluctance that there is no noticeable tendency for the Xux to crowd to one side or another.Firstly, the reluctance of the iron paths is very much less than the air
paths which they have replaced, so the total Xux produced for a given MMF is very much greater. (Strictly speaking therefore, if the MMFs and cross-sections of the coils in Figures 1.6 and 1.7 are the same, many
more Xux lines should be shown in Figure 1.7 than in Figure 1.6, but for the sake of clarity similar numbers are indicated.) Secondly, almost all the Xux is conWned within the iron, rather than spreading out into the
surrounding air. We can therefore shape the iron parts of the magnetic circuit as shown in Figure 1.7 in order to guide the Xux to wherever it is needed. And Wnally, we see that inside the iron, the Xux density remains uniform over the whole cross-section, there being so little reluctance that there is no noticeable tendency for the Xux to crowd to one side or another.

OTHER SUPERIOR PRODUCTS