Pneumatic Actuator - 180 Degree Rotary Actuator
pneumatic actuator used, make sure the valve opens, closing torque,
and then do the valve using a fluid medium, added security value.
For cleaning, lubricating medium increased by 20% Security value;
of water vapor and non-lubricating medium security value by 25%;
non-lubricated dry gas media to increase 60% security value;
non-lubricated gas transmission medium to increase the powder
particles 100% security value. Then the gas supply pressure of
work, find the double-action or single-acting output torque table,
available and accurate actuator signal. Single-acting torque Table,
the minimum time to close the valve spring torque is the torque,
maximum torque is to open the valve spring torque.
Two additional pistons make a third (intermediate) position
possible. The intermediate position is exactly reproducible. To use
for multiple-way valves and pig valves. Safety function with
spring-centered central position
pneumatic twin piston actuator, single-acting and double-acting
version with two additional pistons, pivoting angle 90°+ 90° (180°)
respectively 120°+ 120° (240°)
valve combinations (preferably 3/2-way) corresponding safety
conception respectively requirements.
Installation and maintenance
1, the pneumatic actuator can be directly connected with the valve,
brackets and fittings can also be connected with the valve
installation. Fasteners must not loose connection.
2, to ensure that the actuator output shaft coaxial with the valve
stem is installed, and turn the flexible non-crawling phenomenon.
3, connecting pipes, fittings, accessories, etc. should be clean.
4, solenoid valve scheduled port is always down, when the level up
or when the pipe should be connected so that the exhaust downward.
5, testing should be determined before the channel clear air,
pressure, voltage, signals meet the requirements.
6, compressed air should be filtered, dried, dew point -15 ℃ to
dehumidify the following.
7, solenoid valve should open when debugging to the automatic
position.
8, pneumatic operation, the device should be disconnected manually,
manually operated pneumatic devices should be disconnected.
9, the actuator is installed on a variety of accessories, should be
separately described with reference to use for debugging,
10, under normal operating conditions once a month, once a year
overhaul.
Parameter | Description |
|---|
| Type | Veson 3 Position Pneumatic Actuator |
| Number of Positions | 3 (Open, Closed, Intermediate) 0-45-90 or 0-90-180 or others |
| Actuation Method | Pneumatic pressure |
| Actuator Configuration | Single-acting or double-acting |
| Operating Principle | Air pressure applied to move the actuator's piston |
| Position Sensing | Limit switches or position sensors for feedback |
| Control Signal | Pneumatic signal (typically air pressure or vacuum) |
| Actuator Body | Rigid and durable construction (e.g., metal or alloy) |
| Seal Type | O-rings or other suitable sealing materials |
| Pressure Range | Varies based on application requirements |
| Fluid Compatibility | Compatible with compressed air or other gases |
| Mounting Options | Various mounting options (e.g., flange, clevis) |
| Maintenance | Periodic inspection and lubrication as required |
| Application | Used in various industries for valve or damper control |
