CM-A2 pet bottle blowing machine price
Product Description
CM-A2 Full automatic blow molding machine is suitable for producing
PET/PE and PP plastic containers and bottles in all shapes. It is
widely used to produce the carbonated bottle, mineral water,
pesticide bottle oil bottle cosmetics, wide-mouth bottle and hot
fill bottle etc.
Features of main body:
1). Stable performance with advanced PLC.
2). Automatic preform conveyer to save human cost.
3). Preform self-rotation and infrared pre-heater revolution assure
the even distribution of heat, which improve the bottle shaping
rate, increase the production.
4). High adjusting performance to enable preheat the preforms
perfectly by adjust the voltage control area in the PLC, which
could adjust the temperature of the infrared lights in the
pre-heater, and keep the proper temperature and humidity
invariable.
5). High safeties with security automatic-locking device in each
mechanical action, which will make the production into a perfect
safe environment, in case of the breakdown in certain procedure.
6). Introduce the FESTO air cylinder to avoid contamination and
noise.
7). Satisfaction with different atmospheric pressure for blowing
and mechanical action by dividing the blowing and action into three
parts in the air pressure diagram of the machine.
Main Features
1. After preform injection, the heat is used for bottle blowing, no
need of preform packaging, storage, reh- eating and other working
procedures.
2. The compact structure greatly shortens the production cycle and
enhances productivity.
3. Adopt variable pump and servo motor, maximally reduce energy
consumption.
4. The replacement of the mold cost is far lower than similar
foreign equipment.
Technical parameters
| Main part: |
| Pneumatic part | Valve | SMC |
| Cylinder |
| Electric part | PLC | LG Mitsubishi |
| Operating system | LG /HITECH |
| Relay | OMRON |
| Infrared thermometer | America raytek |
| Note | All of the electrical components adopts CE,UL,CCC approved international advanced high-tech product. |
| Main parameter: |
| Model | CM-A2 |
| Productivity | Depend on bottle design | 1800-2000PCS/H |
| Product type | Body diameter | 20mm-100mm |
| Height | 50mm-350mm |
| Neck diameter | 15mm-38mm |
| Mold | Cavity | 2cavities |
| Mold thick | 240mm |
| Mold | 500*500mm |
| Main machine power | Electrical source power | 380v 3Phase /220v 3Phase 50/60HZ |
| Power | 25kw |
| Really use power | 6kw |
| Air source | LP air compressor | 1.0m3/min 1.0MPa 1set (7.5KW) |
| HP air compressor | 0.7m3/min 3.0MPa 2sets (each set 9KW) |
| Air dryer | 1.0m3/min 3.0MPa 1set |
| Cooling water | Cooling water | 10L/min |
| Size | L*W*H | 1908*1280*1920mm |
| Weight | 2000kg |
| Auxiliary equipment(preform unscrambler) | L*W*H | 276*106*186mm |
| Weight | 250kg |
| Resin available | | PET |
Shanghai-Plastic Machinery Manufacturing Co., Ltd. is located in
Shanghai's Songjiang Science and Technology Park, with a total area
of
238 acres. Its transportation is very c- onvenient, located in the
Shanghai-Hangzhou Expressway and the same three motorway- at the
exit
port, and is adjacent to the city of Shanghai University and
Shanghai Metro Li- ne 9 Terminal --- Songjiang Xincheng Station.
