Rotor Testing Machine Of AC / DC Induction Motor / BLDC Motor
1. Introduction
1.1. Test object: the rotor of motor
1.2. Test items: broken bars, thin bars and so on.
2. Technical specification
Test object | Die-casting rotor |
Display mode | 19” LCD display |
Diameter range
| Lamination height: 100mm(max) Outer diameter:20-100mm Inner diameter:4-29mm |
Test mode | Continuous model: output test result when test over. The motor
continue to collect induction waveforms until press the reset
button, then stop test. Single step mode: the machine stop testing automatically while
output the test result when the test is over. |
Test | Conducting bars quantity, minimum amplitude, maximum amplitude,
synthetical value |
Parameter save | software |
Control mode | Auto/manual |
Working ambient | Temperature 0～40℃,humidity ≤90％RH |
Consumption | ≤ 100W |
3. Feature
3.1. Test fast: after fixing clamp, it takes only 3 seconds to
complete test and output the result.
3.2. Test the broken bar and thin bar due to porosity, sand hole
and residue caused by manufacturing technic or bad material.
3.3. Simple interface: the software is easy to understand and
operate based on independently developed test software.
3.4. Help and support: the software is attached with introduction
and waveforms analysis of testing data.
3.5. The testing supports connection to MES system, and optional
equipped with the extension function of barcode scanning, report
form and QR code printing.
4. Test process
4.1. Set the test items and parameter range for different rotor
models and select the corresponding model before the test.
4.2. Put the rotor on the test bench and fix it.
4.3. Press two start buttons on the panel to start the test, and
the indicating light displays “in test”.
4.4. All items will be test automatically and the operator is not
allowed to touch the machine during the test.
4.5. Pass or fail signal will be triggered after completing the
test.
4.6. Take out the tested rotor and continue to test next one from
step 2.
5. Company overview
