Semi Automatic Box Corrugated Stitcher Paper Carton Making Machine
14. After the carton is formed, the length of the upper and lower
covers is not neat. The toothed belt is seriously worn up and down,
and the gap between the two sides is too large or different. The
paper feed is not sent to the baffle for positioning, and the
switch is stepped on the nail. The carton pressure line is not deep
enough, and the carton is too skewed before being twisted.
Maintenance The semi-automatic nail box has a low failure rate and
high reliability. Maintenance is very important, so do the
following:
1) The upper nail head punches once a day, and the nail head is
cleaned and refueled every 30 days.
2) The lower nail head accumulates in the punch due to the small
wire plating of the nail line, so it must be cleaned frequently,
the nail head must be removed, and the oil is replaced after
cleaning.
3) Feeding belt, bolting shaft, left and right bezel, three gears,
buttering once in 30 days
4) Clutches and brakes must not have oil or water
5) The servo motor must be kept clean to avoid dust cover. Always
clean the servo motor drive cooling filter net.
6) Electrical control box keeps clean and avoids short circuit
caused by dust
7) The inner and outer wire spools should be flexible and
lubricated with butter.
8) The nail head fixed shaft and the left and right baffle fixed
shafts must be cleaned and oil lubricated when moving
9) Upper and lower nail head drive shaft, bolt groove shaft,
transmission screw oil lubrication
10) In the power transmission box, the gear and chain are greased
for 30 days.
Semi-automatic nail box machine troubleshooting
The nail box is the last production process of carton forming, and
its process effect affects the appearance quality of the carton on
the one hand, and affects the use performance of the carton on the
other hand. From the perspective of production technology, the nail
box seems to be a relatively simple process. However, in daily
production, it is inevitable to expose some quality problems.
Therefore, the technical and quality control of the nail box
process cannot be ignored. It is necessary to pay attention to the
serious control and control from the aspects of equipment purchase,
operation technology and material selection. Better prevent or
reduce the chance of quality problems.
In the nail box, it will be found that when the quality of the flat
wire is not good, the wire feeding resistance is large, the wire
spring is too loose or too tight, the wire fixing screw is
loosened, the guide rail is deflected, the gear bite is skewed, and
the bottom die is fixed. When the position of the punch is not
correct and the bottom mold has obvious wear and the like, the
above-mentioned malfunction phenomenon is likely to occur. In this
regard, the solution is to use high-quality flat wire with good
rigidity and smooth surface coating; check whether the parts of the
wire are poorly adjusted and cause jamming; adjust the relevant
parts of the machine to make the wire movement easy and
comfortable; The serious bottom mold should be repaired or replaced
accordingly.
Machine specification
| Max size (A+B)X2 | 3600mm | min length A | 250 mm |
| Min size A+B)X2 | 740mm | Max height D | 2000 mm |
| Max size (C+D+C) | 3000mm | Min height D | 150 mm |
| Min size (C+D+C) | 250mm | Max flay size E | 40 mm |
| Min cover size C | 50mm | Max paper heigh | 900 mm |
| Max cover size C | 560 mm | Machine width | 2850 mm |
| Max width size B | 760 mm | Machine weight(T) | 2tons |
| Min width size B | 120 mm | Machine speed (nail/min) | 500 |
| Max length A | 1120 mm | Nail no. | 1-99 |
