Corrugated Box Making Machine For Carton Stripper,Carton Waste
Introduction
The carton stripper provided a safe economic solution for stripping
your waste paper of die cut sheets ,however cardboard or corrugated
board
The waste stripper is equipped with multi tooth chain drive by a
compressor air motor with an output 2500rpm, its teeth do not cut
the paper ,they catch it , your operator smply need to hold the
device. The waste stripper quickly finished the his work , up to
10times than by hand
Features
For waste margin stripping of cardboard, thin corrugated paper and
common corrugated paper in printing industry, High-speed running
gear is cycle driven through air motor , strip waste margin paper
with sharp teeth gear. The gear use high strength Diamond Compound
after heat treatment, high hardness, wear resistance, long life and
easy replacement .
The product is high efficient manual stripping equipment, stripping
efficiency is improved by 10 times, manual stripping needs hours,
finished only in 10-30 minutes with stripping machine, greatly
shorten the delivery cycle.
Compact configuration,almost the same weight as normal grinder,easy
to use,worker can operate the machine after simple training, No
damage for bonding area while stripping,improve the efficiency of
the following process (gluing / automatic packing)
| Model | | Speed R.P.M | Air cons
| Air pressure | air hose size | N.W |
| KS2590S | small teeth | 2500 | 12 | 6-8 | 8x12 | 4.0 |
| KS2536 | middle teeth | 2500 | 12 | 6-8 | 8x12 | 4.0 |
| KS2536L | large teeth | 2500 | 12 | 6-8 | 8x12 | 4.0 |
| KS2190S | small teeth | 2100 | 12 | 6-8 | 8x12 | 4.5 |
| KS2136 | middle teeth | 2100 | 12 | 6-8 | 8x12 | 4.5 |
| KS2136L | large teeth | 2100 | 12 | 6-8 | 8x12 | 4.5 |
Instructions for use
1. Pneumatic tools are not maintained in maintenance.
2. Pneumatic stripping machine is different from other pneumatic
tools. After one week of running-in period, and keep the chain and
sprocket unimpeded sliding at any time, add a few drops of gear oil
to the chain every half working day to reduce friction. Extend its
use time.
3. First make sure that the machine is connected to the gas source
to ensure that the air pressure is 6-8 kg, and the air pipe is
required to work at 8*12M/M.
4. Before the air pressure is not opened, drive the chain by hand,
whether it can roll freely, otherwise it can't be used. After
adjusting the direction of the paper-cutting machine, fix the
locking screw 38#. Make it unable to swing.
5. Open the slide switch 01#. or the front pressure regulator to
the maximum before working.
6. Inject professional pneumatic tool oil from the air inlet to
lubricate the motor.
7. Press the platen 3# during work to start working.
8. Every day before and after work, be sure to drop three to four
drops of special oil for pneumatic tools from the air inlet and
idle for 2-3 seconds.
