HG-808A Intgrated Vibration Transmitter
I Brief Introduction
The integrated vibration sensor and transmitter is easy to install
on the equipment to be used in conjunction with condition
monitoring systems, such as panel meters, DCS, and PLC, etc. It is
particularly applicable to monitor online the conditions of
important machinery.
The integrated vibration transmitter integrates a shear-mode
piezoelectric accelerometer with amplifier, integrator and
transmitter to output the RMS value of the vibration acceleration,
velocity or displacement (looped power 2-line or 3-line 4-20mA
current signal).
II Technical Specifications
l Accelerometer:
; Shear-mode Ceramic piezoelectric
; Self-temperature-compensation of sensitivity
; Transverse sensitivity max: <5%
; Case: stainless steel, air-tight
; Ground isolated
; Measurement range: 50, 100; 150 m/s2
l Output:
; Value: True RMS or equivalent peak
; Parameter: Acceleration, velocity or displacement
; Line: 2- or 3-line 4~20mA;
; Optional Dynamic voltage output
; Output load resistance: 0~500 ohm
l Frequency response: 5~2000Hz
l Operating temperature (oC): -20~+80
l Power supply: 20~30Vdc looped
l Connector for cable: (SY)×12k×3P
l Connector direction: side
l Sensor installation: one M8 or M5 or M20
l Size: Ø 40 ×73 mm
l Weight: 370g
III Wiring
IV Precautions
1) The sensor must have a close and rigid contact with the item
under test, whose surface must be very smooth. The sensor is
installed with lock washer.
2) The cable and connector can be pasted with a shield of silicone
rubber after being tightened together to prevent them from getting
loose.
