Commodity: Rubber Track 356*152.4*52 for Asphalt Paver
| Applicable machines | various kinds of pavers |
| Material | rubber and steel |
| Specification | 356*152.4 |
| Installation position | Installed on the paver |
The characteristics of rubber tracks
1.Rubber tracks cause less damage to roads than steel tracks, and
less rutting on soft ground than steel tracks
2.A benefit to equipment operating in congested areas, rubber
tracks make less noise than steel tracks
3.Rubber tracks permit machines to travel at a higher speed than
steel tracks
4.Rubber tracks insulated machine and operator from vibraion,
extedin the service life of machine and decreasing operator's
fatigue
5.The ground pressure of rubbr tracks equipped machinery can be
fairly low, about 0.14-2.30 kg/m2, a major reason for its use on
wet and soft terrain.
6. The added traction of rubber tracked vehicles permits them to
pull twice the load of wheeled vehicles of the same weight.
7. Rubber tracks' pulling performance being twice that of wheels,
it permits the lighter vehicles equip with rubber track to do the
same pulling work than that of wheeled vehicles.
The notices of using rubber tracks
1. Adjust the tension of the rubber crawler so that the height, the
variable range is 10-20mm when the machine is lifted. Readjust when
the tension decreases.(Be careful because the rubber crawler may
come off if the tension is too low).
2. Avoid projection from the frame around the rubber crawler,
especially on its inner circumference.(Rubber crawlers are easily
deformed; if it comes into contact with the frame, an accident such
the rubber being cut can occur).
3. Avoid sharp projections when traveling.
4.Avoid turning too fast on concrete roads with a high coefficient
of frction because this can cause accidents such as cutting the
rubber.
5. Be careful that no oil, etc adheres to the rubber track. If it
does, wipe it off immediately.
6. When storing for long periods, keep indoors, away from direct
sunshine and rain.
7. Replace as soon as possible when abrasion of sprockets is
observed
Features:
1. Installation of the Rubber Tracks
A. Too small strength: Easily causes jumping teeth, riding a tooth
or steering failure of the guide wheels and supporting wheels and
leads to track derailment or escapes.
B. Too large strength: Track wire will be deformed at the
elongation by the excessive strain tensile, which will make the
pitch changed, and track core iron and the drive wheels abnormally
worn, also will make teeth touched and the track broken, the
machine power loss larger, track wear exacerbated, belt crack
easier as well as the track life shorter. After the track is
strained, the maximum sag distance is 10-15mm, just as the pitch
below.
2. Attention
In order to extend the life of rubber tracks, please complete the
following work:
A. Never turn urgently on the concrete floor, gravel road, or hard
and sharp road, in order to avoid speeding up the wearing, twisting
and chapping of the rubber track.
B. Try not to work in the rotten field, to avoid rubber track skid
and wear.
C. When the stones or other objects come into the crawler and
chassis, stop immediately, and clear gravels or obstacles.
3. Warns
A. Do not travel on the road full of footstone, spinous-stone,
scrap iron and other objects.
B. Do not drive in the rivers, streams and on the seacast or any
rugged road.
C. Do not make the track unilaterial landing.
D. Forbid aggressive driving.
E. Avoid making a turn rapidly, please slow down and make a turn
gradually.
Warehouse:
