CNG330 Series Low Frequency Online UPS 10-200KVA
Model:CNG330 10-200KVA(3Ph/3Ph)
Nominal Input Voltage: 380/400/415VAC
Output Power Factor:0.8
Frequency: 45-65Hz
Standard features: Back Feed protection; split bypass line
Battery voltage: 384VDC
| Model power | CNG330 10-200KVA |
| 10KVA | 15KVA | 20KVA | 30KVA | 40KVA | 60KVA | 80KVA | 100KVA | 120KVA | 160KVA | 200KVA |
| Capacity | 8KW | 12 KW | 16 KW | 24 KW | 32 KW | 48 KW | 64 KW | 80 KW | 96KW | 128 KW | 160 KW |
| Input |
| Rated voltage | 400 Vac three-phase |
| Voltage range | ±20% |
| Power factor | >0.92with harmonic filter |
| Current harmonic distortion | <5%with harmonic filter |
| Soft Start | 0-100% in10" |
| Bypass Input |
| Rated voltage | 400Vac single-phase |
| Permitted voltage range | ±15%(selectable from ±10% to ±25% from front panel) |
| Rated frequency | 50/60Hz |
| Permitted frequency range | ±2%(selectable from ±1% to ±5% from front panel) |
| Batteries |
| Type | Maintenance-free lead-acid VRLA AGM / GEL;NICd |
| 480VDC |
| Maximum recharge current(A) | 0.2×C10 |
| AC ripple voltage | <1% |
| Inverter Output |
| Number of phases | 3+N |
| Rated voltage(V) | 400Vac |
| Regulation of the output voltage | 380~424Vac phase/neutral(from control panel) |
Crest factor (Ipeak / Irms) | 3:1 |
| Static stability | ±1% |
| Dynamic stability | ±5% |
| Frequency | 50/60Hz configurable |
| Overload | 110% 125% 150% of the rated current for 5h/10'/1' |
| Frequency stability | ±0.05% on mains failure;±2%(selectable from ±1% to ±5%)with mains
supply present |
| Remote signaling | Volt free contacts |
| |
Application:
Servers,
Local area Network(LAN),
Data centers,
Telecommunications,
Electro-medical equipment
High intelligence and reliable power supply:
- Maximum protection for vital mission-critical networks, security
applications (electro- medical)and industrial applications thanks
to its outstanding mechanical and electrical design.
- The load is powered continuously by the inverter with a filtered,
stabilized and regulated sine wave supply. The input and output EMI
filters considerably increase the immunity of the load to mains
disturbances and surges.
- On-line double conversion technology (VFI) with isolation
transformer on the inverter output.
- Watch & Save 3000 software as standard and can be remotely
monitored using the Power Net Guard system from anywhere in the
world.
- Additional battery extension packs allow the standard battery
routine to be extended up to several hours.
Minimum impact on supplies easy sources:
Input current distortion <4% with filter with sinusoidal
absorption to remove the risk of resonance with other input supply
users or phase shift capacitor sets. The absorbed current
distortion is independent of input supply parameters such as
impedance. This enable CNG330 to deliver maximum performance levels
regardless of the installation environment. With these input
features CNG330 can achieve significant savings in terms of sizing
and power supply sources isolation transformers and generators over
less sophisticated power systems.
Maximum battery care:
- Battery deep discharge protection;
- Temperature compensating charger;
- Built-in automatic and manual battery test feature.
Simple to install:
Capability to install the UPS into any distribution system(neutral
not required on rectifier input);
Capability to separate the rectifier/bypass power networks and to
power these from two separate sources, without Galvanic isolation
(Necessary on UPS without an output transformer).
High reliability:
Extremely high short-circuit current to ensure compatibility with
the most difficult transformer applications (lighting, drives and
industrial processes) and an isolation transformer on the inverter
output;
Full microprocessor control with no-break static and manual
bypasses;
IGBT technology.
Back feed protection:
To avoid energy feeding back into the mains supply cause a fault
occur.
Maximum reliability and availability:
Connect up to 6 units in parallel or N+1 redundancy, even of
different power ratings.The UPS continue to work in parallel even
if one of the interconnecting communication cables is disconnected
(CLOOSED LOOP).
Low consumption level:
Selectable Economy Mode efficiencies >98%, which means it can be used in stable
electrical environments to provide power supply continuity when the
mains fail.
Advance communication
- Compatible with TeleNetGuard for remote maintenance;
- Watch & Save 3000 monitoring and shut-down software included, with
SNMP agent, for Windows 2008, Vista,2003, XP; Mac OS X, Linux,
Novell and most popular Unix operating systems;
- Cable for direct connection to the PC(Plug and Play);
- RS232 double Serial port; Installation slot for an Emergency Power
Off (EPO) interface to allow the UPS to be switched off remotely in
an emergency;
- Generator interface: enables desynchronisation of the UPS output
from a generator supply which may be subject to phase and frequency
variations. The interface also enables more economic use of the
battery charge.
Expandability:
The units can be connected in parallel up to 8 units to increase
power availability or redundancy. The single module or the system
can be expanded any time to suit power requirements without
influencing the initial investment.
Other characteristics:
| Remote controls | EPO and Bypass |
| Operation temperature | 0ºC/ + 40ºC |
| Relative humidity | <95% non condensing |
| Noise | 54dBA at 1m | 50-65dBA at 1m |
| Protection degree | IP20 |
| Efficiency smart mode | up to 98% |
| Compliance | Safety:EN 62040-1-1(Directive 2006/95/EC); EMC:6200-2(Directive
2004/108/EC)
|
