2/2 Way NC Circular Seat Solenoid Stem Assembly With No
Thread/Magnetic Solenoid Stem
Know more about Application
1.Mainly used for 13.5mm OD,53.5 height solenoid coil
2.Application in dust-removing equipment/dust collector valve
Dust collector valve: The dust collector solenoid valve is a
compressed air switch for the dust removal system of the pulse bag
filter. Controlled by the output signal of the pulse injection
controller, the filter bag is injected one by one and the
resistance of the dust collector is kept within a set range to
clean the dust to ensure the processing capacity and efficiency of
the dust collector
3.Solenoid Stem has a wide use because the lots of species,low
price and high quality.Can application for other industry with
adjustment
Working principle
The diaphragm divides the pulse solenoid valve into two chambers.
When the compressed air is switched on, the compressed air enters
the back chamber through the throttle hole. At this time, the
pressure of the back chamber will press the diaphragm to close the
output port of the valve, and the pulse solenoid valve is in a
"closed" state. The electric signal of the pulse injection
controller makes the armature of the pulse solenoid valve move, the
vent of the back chamber of the valve opens, the back chamber loses
pressure rapidly, the diaphragm moves backward, the compressed air
is injected through the outlet of the valve, and the pulse solenoid
valve is in the "open" state. when the electric signal of pulse jet
control device vanishes and the armature of pulse solenoid valve is
reset. The outlet of the back chamber is closed, and the pressure
of the back chamber rises to make the diaphragm close to the valve
outlet, and the pulse solenoid valve is in the "closed" state.
Dimension
1.Tube OD:13.5mm
2.Tube height:53.5mm
3.Item weight:53g
4:Movable core height:28.2mm
5.Depth:29mm
6.Voltage:AC/DC
Specification in the image
Special design
1.wIth no screw thread,only a groove in the surface of the
armature.The surface is smooth with no skin needling.
2.Two way two way solenoid stem/armature assembly. with circular
seat
3.Magnetic electric valve part.Electric force to hole the movable
core down and upward.
4.with interior spring design,improving the conversion rate
5.A unique Seal of movable core:Reddish brown seal
process of manufacuring
| Make the drawing in the computer |
| Give drawing to the workers |
| Design manufacture process in the numerical control table |
| Make the sample |
| Test by quality inspector |
| Send the sample or drawing to the customer |
| Ensure to meet requirement and manufacture largely |
| Test again such as pressure test temperture test |
| With no quality problem sent the goods to concumers |
| Adjustment if something wrong with items |
| Make OEM with yours drawing and sample |
