| Test Items | Test Condition and Procedure | Requirements |
| C1 | S.W.R. | Set DUT on Network Analyzer; make individual calibration to test | Directive DUT specification |
| C2 | Antenna
Gain | Set DUT on Antenna Chamber; make individual calibration to test | Directive DUT specification |
| M1 | Vibration | MIL-STD-202G, 201A
Amplitude: 0.03 inch (0.76mm); Freq: 10 to 55 Hz
3 directions; 2 hours for each direction | 1. No Visual Damage
2. Frequency Tol.<= 5% |
| M2 | Random
Drop | Height: 1.5Meter;
3 directions; 1 time for each direction | 1. No parts separated
2. Frequency Tol.<= 5% |
| M3 | Solderability | MIL-STD-202G, 210F, cond. A
Solder iron: 350±10°C; Duration: 5 seconds | 1. Mounted on PCB
2. No Visual Damage |
| M4 | Terminal-
Pull Test | MIL-STD-202G, 211A, cond. A
Holding with individual specification; force applied
toaxis of terminal | 1. Directive DUT specification
2. Frequency Tol.<= 5% |
| M5 | Dimension | Inspection of dimension, color, material, package,
surface process | Directive DUT specification |
| E1 | Salt Spray | MIL-STD-202G, 101E, cond. B
Temp: 35°C; RH: >= 95%; NaCl solution: >= 5%;
Time: 48 hours | After 2 Hours Recovery
1. No Visual Damage
2. Frequency Tol.<= 5% |
| E2 | Humidity | MIL-STD-202G, 103B, cond. B
Temp: 40°C; RH: >= 95%; Time: 48 hours | After 2 Hours Recovery
1. No Visual Damage
2. Frequency Tol.<= 5% |
| E3 | Thermal Shock | 1 Cycle: - 40°C(30 minutes) to + 80°C (30 minutes)
Cycles: 24 | After 2 Hours Recovery
1. No Visual Damage
2. Frequency Tol.<= 5% |
| E4 | Life(High Temp.) | MIL-STD-202G, 108A, cond. A
Temp: 85°C; Time: 96 hours | After 2 Hours Recovery
1. No Visual Damage
2. Frequency Tol.<= 5% |
| R1 | RoHS | With Reference to IEC 62321:2008 with flow chart | Directive RoHS 2002/95/EC |
| R2 | PFOS | With Reference to USA EPA 3540C:1996 by LC/MS | Directive RoHS 2006/122/EC |
| R3 | PFOA | With Reference to USA EPA 3540C:1996 by LC/MS | Directive RoHS 2006/122/EC |
