Manual Electric Heating Thermostat for Underfloor Heating System
- Mounted on the surface of the wall indoors
- Temperature control range +5/+40℃
- Applied in the auto-control system of space heating
- LED turned onwhile heating
Technique Parameters
Voltage: 220VAC
Power consumption: 5VA
Temperature control range: 5~40 ℃
Temperature limit range: 25~55 ℃
Power save mode temperature: 5℃
Degree of protection provided by enclosure: IP20
Outer sensor: length of cable 3m
Calibrating
When indoor temperature reaches steady state, user could calibrate
the heating thermostat to make the temperature reading be the same
as the real room temperature.
Restriction of Control Knob Adjusting Range
The lock mechanism under the controlknob can be used to restrict
the adjusting temperature range. User can lock the adjusting range
(e.g.20-25℃) as long as loosing the screw C (shown in Fig.2).
Mounting of Outer Sensor
Please place the casing under the floor with the outer sensor in,
the terminal of which should be thickened and placed on the top of
the concrete layer. Sensor cable can be extended to 50m with other
cables if necessary. If multi-core cable is used as extended cable,
extra cable core should not be used for power supply (e.g. power
supply for heating cable) for avoiding the interference of voltage
signal to the heating thermostat. If there is shielded cable in the
extended cable, shielded cable should not be connected to ground
but to terminal 7. It is recommended that the extended cable and
casing should not be shared with others.
Outer sensor and its resistance
| Temperature( ℃) | Resistance(Ω) |
| 5 | 22070 |
| 10 | 17960 |
| 20 | 12091 |
| 30 | 8312 |
| 40 | 5827 |
Package
Individual white box and outer carton, 64pcs in one carton
Component Name
Writing Diagram
