IEC 60468 DC Low Resistance Conductor Resistivity Tester for Wire
and Cable
Usage:
The equipment used to test the resistance of a conductor of a unit
length (such as wire and cable) is the equipment used in
laboratories, wire production sites, quality control departments,
and wire and cable manufacturers.
Conductor resistance fixture:
Meet the requirements of GB3048.2, GB3048.4, GB 5013, GB5023, IEC
60245-2, IEC 60227, IEC 60468 and other requirements.
Measuring wire length: 1m
The largest measuring section: 120mm2 (diameter: 0.5~12mm); 2000mm2
(maximum diameter: 25mm); 8000mm2 (maximum diameter: 50mm)
Current and voltage terminal spacing: 60mm
The fixture is used with a bridge or a DC low resistance tester,
which can greatly reduce the error of measurement. The clamp has
two sets of interchangeable chucks and a pair of miniature
terminals. The current end is shaped as a right-angled tiger mouth
and can make the current end The sample is in good contact, so that
the current is evenly distributed in the core to be measured,
reducing the influence of the contact resistance on the
measurement; suitable for measuring the DC resistance of the
conductors of the round wire, stranded wire and fan wire, and also
measuring the following 0.1 mm Specifications enameled wire.
DC low resistance tester:
DC low-resistance tester is an intelligent, wide-range and precise
DC resistance tester. It is suitable for transformer and inductor
copper resistance, relay contact resistance, switch, connector
contact resistance, wire resistance, component solder contact
resistance, and printing. Board lines and solder hole resistance,
metal detection and so on. Applied to the production line, you can
use the HANDLER interface and GPIB interface (option) to output
good/bad signals to improve the automated testing capabilities of
the production line.
Basic accuracy 0.1% reading + 2 words
Display range 0.001 mΩ to 19.999 kΩ
Test Current 1 A, 100 mA, 10 mA, 1 mA, 100 μA
Range 20 mΩ, 200 mΩ, 2 Ω, 20 Ω, 200 Ω, 2 kΩ, 20 kΩ
Each range resolution 1 μΩ, 10 μΩ, 100 μΩ, 1 mΩ, 10 mΩ, 100 mΩ, 1 Ω
Measurement speed (times/second) Fast: 10, Slow speed: 2.5
Range mode Automatic, keep
Operating temperature, humidity 0°C — 40°C, ≤90% RH
Power Requirements 198 V - 242 V AC, 47.5 Hz - 52.5 Hz
Power consumption ≤30 VA
Size (W×H×D) 270 mm×110 mm×330mm
Weight about 3.3 kg
