6.5 Inch OBD2 Race Car Dashboard LCD Digital Race Dash Display (
DO903 )
| Brand | SINCO TECH |
| Name | DO903 OBD DASHBOARD |
| Display | Digital |
| Operating Voltage | 9V-16V |
| Application | Vehicle that meets the OBDII standards |
| Part List | Display,Power Wire,Bluetooth OBD unit,Instructions manual |
| Parameter Display | 1.RPM 2.Speed 3.Fuel Level Input (%) 4.Absolute Throttle Position (%) 5.Calculate Load Value (%) 6.Engine Coolant Temperature (℃) 7.Voltage (V) 8.Time 9.Bottom display. |
Bottom Display
| 1.Date 2.Engine Rpm(RPM) 3.Intake Manifold Absolute Pressure(MAP) 4.Air Flow Rate From MAF(MAF) 5.Intake Air Temperature(IAT) 6.Ignition Timing Advance For 1#Cylinder(ITA) |
A .LED
Four LED light is on each top side of the frame and will light
according to the different RPM. The light color is GREEN, GREEN,
YELLOW, RED from bottom to top.
B .UP SELECT KEY
choose and adjust the number value
C .DOWN SELECT KEY
choose and adjust the number value
D .MENU KEY
set up MENU and confirm functions
E .EXIT KEY
exit or cancel the setting.
F. POWER PLUG
There are two power plugs on the display, one is on the left,the
other is on the right. You can connect Mini USB to either plug.
(NOTE: PLEASE USE SPECIAL POWER CABLE IN DO903DASHBOARD KIT. OTHER
STANDARD MINIUSB IS NOT SUITABLE FOE THE DASHBOARD. IF USE, WILL
DAMAGE THE DASHBOARD)
DISPLAY :
1 Engine RPM
2 Speed
3 Fuel Level Input (%)
4 Absolute Throttle Position(%)
5 Calculate Load Value (%)
6 Coolant Temp0erature (℃)
7 Voltage (V)
8 Time
9 Bottom Display
1.DO903 OBD dashboard contains a display and a bluetooth OBD unit.
Please connect bluetooth OBD module to the car OBD plug and connect
the power cable of display to car power outlet.
2.There are two power plugs on the display, one is on the left, the
other is on the right. You can connect Mini USB to either plug.
(NOTE:PLEASE USE SPECIAL POWER CABLE IN DO903 DASHBOARD KIT. OTHER
STANDARD MINIUSB IS NOT SUITABLE FOE THE DASHBOARD. IF USE, WILL
DAMAGE THE DASHBOARD)
3.Two keys are located each side of the dashboard display. “
MENU/OK” key is on the left top to set up MENU and confirm
functions.“EXIT/CANCEL” key is on the left bottom to exit or cancel
the setting. “UP ”,“ DOWN”keys are on the right top and right
bottom to choose and adjust the number value.
4.Light sensor is on the middle of the dashboard. The display
screen background changes in four levels based on the natural
light. Four LED light is on each top side of the frame and will
light according to the different RPM. The light color is GREEN,
GREEN, YELLOW, RED from bottom to top.Make sure to connect OBD
module with car OBD plug then start the car. When get power , the
display will search for OBD signal and connect it automaticly.
DO903 Suit For All Automatic Diagnostic System OBD2 Stands.
