2 Inlet 2 Outlet Fiber Termination Kits horizontal Type FO 24 to
144 Cores Closure Joint Box
2 inlet 2 outlet ports provided: 4 ports suit for single fiber
cable with max Ø16 and minimum Ø7mm.
The fittings provided with GJS-8005: 2pcs of special wrench,
earthing wire, nylon tie, labeling paper, desiccant, 4pcs of
elastic ring, 4pcs of plastic gaskets.
Accessories for customers' selection: earthing deriving device,
pressure testing valve, buffer tube for bunchy fiber, 1 piece metal
hoop
Specification
| Model | Dimension (mm) L*W*H | Material | Sealing Structure | Cable Capacity (Port) | Max Capacity (Core) |
| GJS98 | 160*420 | PC | Mechanical seal | 2 in 2 out | 144 core bunchy fiber |
Operations
Choose the cable loop with proper outer diameter and let it go
through the optical cable. Peel the cable , take off the outer and
inner housing, as well as loose contract tube, and wash off the
filling grease, leaving 1.1~1.6mfiber and 30~50mm steel core.
Lay the left fiber in the melting and connecting tray evenly, and
fix the winding fiber with nylon ties. Use the trays from the
bottom up. After all the fiber has been connected, cover the top
layer and fix it.
position it and use the earth wire in accordance with the project
plan.
Sealing the cable retainer nearing the inlet of splice closure and
the joint of the cable rings with sealing tape. And close the
unused inlets with plugs, with exposed concave parts of the plug
sealed with tapes.
Then put sealing trips into the sealing groove on the sides of the
shell and grease the concave part of inlet of the body between the
two parts of the shell.
Then close the two parts of the shell and tighten it with stainless
steel bolts. The bolts should be screwed tightly with balanced
force.According to the laying requirement, position and fix the
hanging tool .
Fix the cable pressing card and cable, together with cable
reinforce steel core. If the diameter of the cable is less than
10mm, first bind the cable fixing point with adhesive tape till the
diameter has reached 12mm, then fix it.
Lead the fiber into the melting and connecting tray, fix heat
contract tube and heat melt tube to one of the connecting fiber.
After melting and connecting the fiber, move heat contract tube and
heat melt tube and fix the stainless (or quartz)reinforce core
stick ,make sure the connecting point is in the middle of the
housing pipe. Heat the pipe to make the two into one. Put the
protected joint into the fiber-laying tray.(one tray can lay 12
cores)
