Surge protection device for power supply system , lightning
protection system
Working principle of product
When the surge protector has no voltage, the impedance is very
high, which means that the circuit breaker is open. When the
voltage occurs, the impedance drops to a few Europe, and the surge
current will flow through the surge protector and will not enter
the device. At the same time, because the surge protector has a
small impedance at this time, the voltage on both sides of the
surge is relatively small, and because he is in parallel with the
protected equipment, it prevents the equipment from suffering from
large surge power. Pressure, so as to play the effect of discharge
and pressure limiting.
Structure and Principle
SPD is a port, shocking protection, indoor-mounted installation,
voltage-limited.
SPD hold disconnector inside, when SPD breakdown failure by over
heating, the disconnector can remove from the power grid
automatically, and show indication signal. When SPD is working
properly, visible window display green, it display red when it
breakdown and disconnect.
1P+N,2P+N,3P+N SPD consist of 1P,2P,3P SPD+NPE zero ground
protection module, apply to TN-S, TN-C-S and other power supply
system.
Product features
1. advanced production process and beautiful appearance
2. the product has many interfaces and is easy to use. It doesn't
need to worry about the number of interfaces.
3. self protection voltage is more than self protection, automatic
disconnection and recovery.
4. adopt the latest arc extinguishing technology to avoid fire.
Product specification
| Model | | TRS4-D10 | TRS4-D20 |
| Rated Operating Voitage | UC | 275 | 275 |
| Voltage protective level | Up(KV)≤ | 0.9 | 1.1 |
| Max discharge current | Imax(8/20μS) | 10 | 20 |
Nominal discharge current
| In(8/20μS) | 5 | 10 |
| Ressponse time | NS | <25 |
| Lndication of invalidation | Aging invalidation:green Normal,red:Invaldation |
| Operating condition | Temp:-40℃~+70℃ |
| RH≤95%(25℃) |
| Sea level elevation≤3km |
Remote signal function
| Can also picking |
| Remarks | Other max continuous operating voltage can be customized |
product description
The power supply surge protector, also known as the power supply
lightning protection device, is suitable for the AC 50/60HZ, the
rated voltage 220V/380V power supply system, the indirect lightning
and direct lightning impact or other instantaneous overvoltage
surge protection, suitable for home housing, the third industry and
industrial field surge protection requirements, with relative
phase, relative. The relative middle line, the middle line to the
ground and its combination protection mode.
Use of attention
1. when the current carrying conductor is part of the closed loop,
the circuit and the induced voltage decrease as the conductor
approaches the circuit.
2. generally speaking, it is better to separate the protected
conductor from the non protected conductor, and it should be
separated from the ground wire. At the same time, in order to avoid
transient orthogonal coupling between power cables and
communication cables, necessary measurements should be made.
3. data line: more than 2.5mm2; when the length of more than 0.5
meters of more than 4mm2.
Company profile
Thor is following the international quality system standards, is
ISO 9001 certified and our technical standards are in line with
GB18802.1-2011/IEC61643-1.
