1000gu Single angle Glossmeter NHG60 Intelligent Gloss Meter with
large touchscreen
Gloss is measured by measuring the reflectance of a material on the
incident light beam. The measurement of the reflectance should be
done with the following rule: angle of incidence is angle of
reflection.
Gloss is highly dependent on the angle at which the material is
viewed. If have an observer perpendicular to an object can hardly
looks luster, but when he looks almost parallel to the material,
there may be a gloss observed.
When measuring the gloss, it is therefore important that the angle
has been standardized. Typical angles are 20 °, 60 ° and 85 °. For
a high gloss, the gloss is generally by 20 °, resulting in lower
gloss measured at 60 °. Matte materials are measured at 85 °.
In addition to the method in remission, the gloss can also be
measured by the amount of reflective (according to angle of
incidence is angle of reflection) to compare light with the amount
of light scattered (which can be seen at other angles than the
angle of refraction.
Single-angle gloss meter, measuring angle 20 ° / 60 ° / 85 °3.5
"TFT touch screen, 5,000 memory positions comes with PC software
raportage20 ° 0-2000GU; 60 ° 0-1000GU; 85 ° 0-160GUHighly accurate
± ± 0.1GU 0.2GU, ± 0.2% GU ergonomic design
Features:
1. 60° angle for semi gloss
2. Display 5 sets of measurement data, good for comparison
3. Measuring mode: basic measurement, statistical measurement,
continuous measurement, QC measurement (only for GQC6 software).
4. Continuous mode to check uniformity over large areas
5. Connect to PC, more extend functions
6. Input gloss value manually
7. Large touch screen operation, easy to use
8. Beauty appearance, good man-machine communication interface
9. Powerful functions to meet many different requirements
10. Large storage to save over 5000 data
11. Built-in lithium ion rechargeable battery.
Range
Measurement Range Repeatability
Reproducibility | 0-10GU 10-100GU 100-1000GU
± 0.1GU ± 0.2GU ± 0.2%GU
± 0.2GU ± 0.5GU ± 0.5%GU |
Storage
Measuring Mode&Storage | Basic Mode: 1000 Statistical Mode: 5000 Continuous Mode: 5000 |
Standard
Measurement Standard | Comply with Standard ISO 2813, GB/T 9754, ASTM D 523, ASTM D 2457 |
Measurement Standard | Conform to the Working Requirements for JJG696 First Class
Glossmeter |
Specification
Parameters | Gloss Meter NHG60 |
Measuring Angle | 20° Comply with Standard ISO 2813, GB/T 9754, ASTM D 523, ASTM D 2457 |
Measuring Area | 60°: 9x15mm |
Measuring Range | 60°:0~1000GU |
Division Value | 0.1GU |
Chromaticity Response | Corresponding with CIE 1931(2°) under CIE C Light Source |
Tolerance | ±1.2, ±1.2% |
Measuring Time | 0.1s |
