Auto Metallographic Cutting Machine Rotation Speed
500-3000rpm Specimen Cutting Machine
Brief Introduction:
iCut-413 metallographic sample cutting machine has automatic and
manual cutting modes. With the optional X axis worktable, it has
automatic and continuous cutting function along the Y axis.
With the function of adjusting the height of chief axis, it is used
in a variety of shapes, sizes and materials sample cutting. The
cutting capacity can meet the daily production inspection and
laboratory detection for cutting samples.
Feature:
1, Rotation speed was adjustable from 500RPM to 3000RPM, and the
speed stability won’t be changed due to the load.
2. Available to use small and thin diamond cutting disc or big
abrasive cutting disc. It compensates the wear and tear of cutting
disc, effectively improves the cutting disc and saves the cost.
3. With the optional X axis worktable, it can realize the
continuous cutting along the Y axis under automatic mode.
4. With horizontal automatic or manual feed mode, flexible feed
mode and large feed stroke, it can be applied to large work piece
cutting.
5. It can choose the program to control feeding for accurate
feeding control.
6. With large sample observation window, it is more convenient for
user to observe sample cutting process.
7. With the exhaust device, it can guarantee the efficient
discharge of steam and smoke when cutting, and make the observation
more clearly.
8. With LED lighting design regulation, it can realize the
effective illumination of the whole area of cutting room.
9.The filter tank adopts a magnetic system, when the circulating
water goes through the magnetic system, the metal cutting debris
will be sucked out by the magnetic system and excluded out. It
increases the cutting effect of the sample and the frequency of use
of circulating water, and avoids the blockage of the drainage
system of laboratory.
Technical Specifications:
| Cutting Mode | Manual Cutting, Automatic Cutting |
| Cutting Disc Type/Size | Diamond/Resin; 250 x 2 x 32mm, 300 x 2 x 32mm |
| Rotation Speed | 500-3000rpm |
| Lifting Stroke | 50mm |
| Lifting Method | Slewing hand wheel control |
| Stainless flange Plate | 80mm |
| Max. Cutting Ability | Max 90mm Round bar |
| Feed Speed | 1-40mm/min, adjustable |
| Feed mode | Automatic mode, Manual mode |
| Feed Method | Horizontal feed |
| Y axis travel | 260mm |
| X axis travel | 40mm |
| Size of cutting platform | Size: 435*300mm, 12mm groove T type working table |
| Cutting fixture | Rapid push and pull type vise, one set each for left and right
operation. Jaw height: 60mm. |
| Lighting | Built-in LED lighting |
| Cooling system | Three cooling water and one cleaning water |
| External circulation tank | 88L |
| Motor | 3KW Frequency conversion motor |
| Power supply | 380V/50HZ/3Ph |
Metallographical Cutting:
When cutting a specimen from a larger piece of material, care must
be taken to ensure that it is representative of the features found
in the larger sample, or that it contains all the information
required to investigate a feature of interest.
One problem is that preparation of the specimen may change the
microstructure of the material, for example through heating,
chemical attack, or mechanical damage. The amount of damage depends
on the method by which the specimen is cut and the material itself.
Cutting with abrasives may cause a high amount of damage, while the
use of a low-speed diamond saw can lessen the problems. There are
many different cutting methods, although some are used only for
specific specimen types. iqualitrol provides the iCut-864 low speed
diamond saw for cutting OM (optical microscope), SEM (scanning
electron microscope), and even TEM (transmission electron
microscope) specimen.
