1. Please charge battery at least 5 hours before first-time use.
2. Turn off power switch before charging. Charging indicator shall
lights on RED when charging the battery , the indicator will turn
to GREEN color while finished.
3. Please install antennas and tight up
according to the number indicator.
Kindly refer to the picture below .
4. Turn on the power switch and the Po
wer LED shall light in Green and the LED
of each band will turn on, too .
5. Don’t suggest using while charging.
( The operational temperature may too high about 7 5 ° C normally.)
Function Introduction
Each band could be chosen operating or not.
1. Find the dip switch on the side of the device as below left
picture.
The number indicators are corresponding to the number of antennas.
2. Eight arrows toward from OFF to ON (default), by dip switching
ON →OFF, each band could be disable.
3. The corresponding LED indicator shall be turn off.
Followings are the details of the way to choose to different
purpose
Disable GSM,CDMA,DCS&PCS
Jam WIFI,GPS,3G,4GLTE,4GWIMAX only.
Step 1. Be sure the power is off.
Dip switching the 1&2&3arrow from ON → OFF.
Step 2. Disconnect the first & second& third antenna (No.1&2&3)
and cover the connector
with the hat.
By finished two steps allow to do step 3.
Step 3. Turn ON the power.
The device could be operated without band GSM,CDMA,DCS&PCS
Step 4. The LED will indicate that which band is operating.
You can following these steps to turn ON or OFF each Jam band you
want.
