1 . 5 - 3mm High speed Steel Wire Straighten And Cutting Machine
description
Is the position of the roll and straightening products direction as
a point of view, two or three big initiative pressure roller,
driven by motor to rotate the same, on the other side of the
several small roller is driven pressure roller, they are against
the rotating round rod or pipe friction of rotating rolls for
products to achieve the required compression, these small roller
can adjust the position simultaneously or respectively forward or
backward, generally, the more the number of roller straightening
products products after the higher precision is the roll bite into,
continuously make linear or rotary motion, thus make the products
in terms of compression bending under flattening deformation,
finally achieve the goal of straightening
Features
Before starting, check that the hydraulic station of hydraulic oil
of reducer transmission case whether gear oil filling up before
starting the main motor, the examination of the Angle adjustment
and the hydraulic system working pressure all lubricating points
into the lubricating oil, check the mechanical transmission part of
the operation condition to make the shipment wear labor insurance
supplies, flexible operating personnel shall not leave after boot
string in the hydraulic station of hydraulic oil temperature after
reaching stable, the straightening roll up to the initial position
of artificial material, steel tube will be delivered after the
third of straightening roller straightening roller pressure on the
clamping to start the main motor, go round steel tube straightening
machine stop at the same time, stop the straightening straightening
roller, the straightening roll up, send for inversion of
straightening straightening of steel pipe, can pass on the reversal
of the knob, make the host inversion and reverse straightening main
motor stop, stop the straightening straightening roller, the steel
tube was returned to the starting position, to repeat the next stop
after straightening procedure instruction, total power close, can
not arbitrarily change the program controller
parameters
| Power | 4.2KW | 17KW | 34KW |
| Voltage | 380V/440V/415V/220V |
| Model | CK-1.5-3/3000-Q | CK-3-6/3000-Q | CK-5-12/12000-Q |
| Brand Name | FZ |
| Place of Origin | China Hebei | China Hebei | China Hebei |
| Usage | Wire | Wire | Wire |
| Type | Straightener&cutter |
| Wire Diameter | 1.5-3mm | 3-6mm | 5-12mm |
| Cutting Length | ≤3000mm | ≤3000mm | ≤12000mm |
| Cutting error | ±1mm | ±1mm | ±1mm |
| Cutting Knife Material | Alloy | Alloy | Alloy |
| Cutting Speed | 100-130m/min | 100-130m/min | 90-130m/min |
| Control Mothod | PLC |
| Wire Material | Cold drawing wire and Galvanized wire |
| Color | White and yellow | White and yellow | White and yellow |
| Straightness | ≤2mm | ≤2mm | ≤2mm |
| Special Requirements | Can be customized | Can be customized | Can be customized |
