333mv Custom AC Inductive Current Clamp with 2.5 Meters Cable
In electrical and electronic engineering, a current clamp. current
probe is an electrical device having jaws which open to allow
clamping around an electrical conductor. This allows measurement of
the current in a conductor without the need to make physical
contact with it, or to disconnect it for insertion through the
probe.GFUVE Model Q110 current clamp is a high accuracy ct, the
advanced design ensures enhanced linearity and the jaw opening
system provides enhanced safety. GFUVE offer customize series based
on Q110 to apply in different testing conditions.This product can
be used in large current situation; also can cooperate to cable
fault tester and cable identification device, used for cable test
work.
Current probes are key to the successful design of electrical
devices, testing instruments,
and electronic parts. Probes work with testing devices are ideal
for measuring currents with high accuracy making them
indispensable tools for evaluating current consumption and control
current. In recent years,
customers are seeking current probes with high sensitivity to
increase the accuracy of design and
verification.GFUVE offers wide range of current sensors for its
portable power analyzers. The
products included in this range can be used to measure current
levels from a few mA to
up to several thousand amperes.
Features:
Holding wire diameter: φ110mm
Dimension: 163mm×310mm×34mm
Load capacity: mA output≤4Ω,
1A output 0.1Ω, 5A output 2.5VA
Installation: clamp type
Output mode: lead output
Applications
1. Electric energy meter calibrator (on site)
2. Double clamp type ground resistance tester
3. Double clamp type phase volt-ampere meter
4. Digital multi-meter
5. Multi-function energy meter
6. Oscilloscope
7. Power quality analyzer
8. Matched instruments
9. Calibration instrument on site
Parameter
| Electrical parameters |
| Ratio | 1000: 1 or 2000:1 (customized) |
| Accuracy class | 0.2%, 0.5%, 1% |
| Primary current | 0 - 1000A AC |
| Secondary current | 0 - 5A AC (customized) |
| Max. Cont. Input current | 1200A |
| Over voltage category | CAT III 600V |
| Output signal (AC current) | 500mA,1A,5A AC at nominal input current |
| Output signal (AC voltage) | 333mV,500mV,1V,5V AC at nominal input current |
| Frequency range | 40Hz-2000Hz |
| Dielectric strength | 3KV 50Hz/60Hz at 1 minute |
| Temperature range | -20°C to +55°C |
| Output | 2.5 meter cable with D01 connector |
| Max. voltage not insulated conductors | 600 V |
| Standard | EN 61010-1, EN 61010-2-032, IEC60044-1 |
| Installation | Clamp type |
| Output mode | Lead output (2.5m) |
| Mechanical parameters |
| Dimensions (L x W x H) (mm) | 163 x 310 x 34 |
| Weight (g) | 900 |
| Holding wire diameter (mm) | φ110 |
| Max. jaw opening (mm) | 110 |
| Jaw color | Black |
| Material | PC+ABS+Polycarbonate, UL94 V0 |
Photos
