B Mode Veterinary Instrument Ultrasound Scanner For Big Animal
Installation
● Power Connection
Inspect the equipment’s power source, after confirming it is within
the range of power source, insert one end of the power line into
the “Power Socket" on the back panel of the main frame (refer to
figure 2), and connect another end to the single phase three-pin
plug to ensure safe earth of the B Type Ultrasonic Diagnosis
Equipment.
● Video Output
Connect Q9 plug, one end of the video line with the “video output”
socket of the equipment’s back panel, and connect another end with
the screen or the image processing equipment.
● Connection of RDL—96 Probe Connector
First, set the set bar on the probe connector to “Open” position,
insert the location pin straight into the location hole on the gang
socket, then set the set bar on the probe connector to “Lock”
position, finishing the connection between the main frame and the
probe.
Warning:
1. Don’t move or insert the plug of the connector for fear of
damaging the probe and main frame; once the probe and the main
frame are connected, please do not move or insert the probe for
fear of causing loose contact. Moving or inserting the probe can be
conducted only when the machine is shutdown.
2. For double probe faucet machine, the lower one of the two
faucets is the standard probe opening, the higher one is the
selective probe opening. Misconnection should be avoided by all
means.
● Installation VGA Output
The equipment, equipped with DSTN processing module, can display
image on colorful screen by inserting VGA input plug of the
colorful screen or line-by-line screen into the “VGA Output” socket
on the back panel and tightening it, and then inserting the power
source plug into the standard three pins socket of the power
source.
If any questions,please feel free to contact me.
