QTZ25 3008 Small Topkit Tower Crane Free Standing Height 25M
Short Parameters:
1. Model: QTZ25(TC3008) Topkit Tower Crane
2. Type: fixed and external climbing
3. Jib length: 30m
4. Tip load: 0.8t
5. Max.laod: 2t
6.Freestanding height: 25m
7. Max.Height: 60m
Specification
| Rated Lifting Moment | 250KN.M |
| Rated Loading Capacity | 2t |
| Max. Lifting Load | 2t |
| Tip Load | 0.8t |
| Max. Lifting Height | 60m |
| Free standing height | 25m |
| Rope length | 280m |
| Span | 30m |
| Working range | 3 to 30m |
| Slewing speed | 0.6/0.3 r/min |
| Trolley peed | 20/30 m/min |
| Jacking-up speed | 0.4 m/min |
| Power supply | 380V/50Hz or others |
| Power Capacity | 17.7Kw |
| Electric switch box | Schneider |
| Hoisting speed | 65/32/7 m/min |
| Mast Section | 1.5*1.5*2m, 125*10mm /angle steel /Q235B |
Technical Features
1)Advanced technical specifications:
Max. Radius is 30m, the static height is 25m, it can reach up to
max. height 60m by adding mast sections and anchorages / tie
device.
2) This Small Tower Crane / Mini Tower Crane used for lower story
buildings construction, normally 4-10 lays.
3) It adopts internationally well received beautiful shape. Good
looks
4) High working speed and excellent speed regulation performance.
5) The cabin / operation room is independently installed externally
with good vision and large space.
6) Equipped full sets safety devices so as to ensure reliable
working condition of tower crane.
Some parts
1. The External climbing tower cranes is fixed to the ground on a
concrete base.
2. The base is then attached to the mast which gives the crane its
height.
3. Further the mast is attached to the slewing unit that allows the
crane to rotate.
4. On top of the slewing unit there are three main parts which are:
the long horizontal jib, shorter counter-jib, and the tower head.
5. The long horizontal jib is the part of the crane that carries
the load.
6. The counter-jib carries a counterweight, usually of concrete
blocks, while the jib suspends the load to and from the center of
the crane.
7. The crane operator either sits in a cab at the top of the tower
or controls the crane by radio remote control from the ground. In
the first case the operator's cab is most usually located at the
top of the tower attached to the turntable, but can be mounted on
the jib, or partway down the tower.
8. The lifting hook is operated by the crane operator using
electric motors to manipulate wire rope cables through a system of
sheaves.
9. The hook is located on the long horizontal arm to lift the load
which also contains its motor.
Photos
