Low price Manual Swipe Magnetic Stripe Card Reader For Restaurant
Receipt
Power Supply +5V DV ±5%
Power consumption 40mA(max.)
Operation Locus Indoor use
Card Standard ISO7811/7812
Track Position ISO 1 (IATA) ISO 2 (ABA) ISO 3 (MINTS)
Recordi7ng Density 210 BPI 75 BPI 210 BPI
Recording Capacity 79 Characters (7bits) 40 Characters (5bits) 107
Characters (5bits)
Interface USB
Card Thickness Plastic 0.76 ± 0.08mm
Head Function Read only 1.5mm
Operation Speed 10 ~ 150cm
Life of Head 500,000 card passes (1 pass : one swipe)
Error Rate 0.5% Lass Than (JSE Test card)
Directions for use
Magnetic stripe card reader and writer machine connected to PC
(terminal) right after, can be the following:
1, set communication parameters According to the reading and
writing at the bottom of the machine label instructions will set
the switch to the right position, consistent with the
superordination machine parameters (terminal).
2, electricity self-inspection Electricity or received a hard reset
after the command, red, yellow, green light is shining at the same
time, three seconds after all out, with a buzzer, self-checking by,
otherwise the self-check error and long bright red light.
3, write MSR-001 series machine after receiving written command
magnetic stripe card reader and writer, and the yellow light is
lit, the operator is the trademark, magnetic stripe for the body,
the magnetic card or the passbook from right to left across the
slot at a constant speed.If write correct the yellow green lights
out, a buzzer rang;If not right, the yellow indicator light, the
red indicator lights, buzzer rang three times.
