All kinds of brand feeder calibration jig are all can supply ,such
as FUJI YAMAHA SAMSUNG PANASONIC JUKI
This product adopts CCD and 50 times the magnifying gl, observed by
MONITOR feed, the thimble up and down movement, LEVER wear, reduce
material frame caused by poor feeding problems, very good to
improve the yield of the mount with help.
1.The operation is simple, the appearance is simple and compact.
2.The three shafts of X, Y and H adopt high precision gear
drive,Precise and reliable.
3.50 times larger CCD to make the picture clearer.
4.Equipped with a standard correction ruler to adjust the suction
Center.
1.14 inch monitor
2.CCD fifty times zoom lens set.
3.1pcs Correction bar.
1.Power supply: AC220 (50HZ)
2.Rated power: 20W
3.Size: 500W*350L*550H
4.Weight: approx. 45Kg
1.Please install the monitor on the disk and insert the CCD out
signal line into the video signal input interface of the display.
Connect the monitor to the 220V power supply
2.Turn on the CCD and monitor power, the monitor will have a cross
cursor display; if not shown, please check the power and signal
line is correct.
3.adjust the brightness and contrast of the display to display
clearly.
1.Fit the calibration ruler to one of the best FEEDER in production
and place the FEEDER on the placing platform
2.Adjust the focus H axis, so that the display to the FEEDER
suction position, hole center, in the display of the cross cursor
intersection to clearly visible, and then adjust the X, Y axis, so
that the FEEDER suction position, small hole at the center of the
display
