Maintenance
1)Keep the barrier gate clean.
2)Check the joints every month in case of any loose parts.
3)Check the spring elasticity after barrier gate running
30,000times
4)Check the easily worn-out parts(like spring,limit switch)every
half year and renew it.
5)Remote control distance will be shortened or not work in cases
like big object screening, battery run out.extreme weathers.
Our Service :1. Our Factory has 8 years OEM/ODM experiences in the line of
barrier gate .
2. Prompt delivery time. Usually we keep stock of standard model
which ensure the prompt delivery.
3. We accept OEM/ODM orders to meet the requirements of clients.
4. Trial order is acceptable. Clients can buy sample and test it
before bulk order.
5. Online technical support makes it carefree to be our business
partner.
6. A variety of transportation for your choice. Sea shipment, air
cargo or express, depends on your demand.
7. Factory can be visited on working days. Clients are warmly
welcome to visit our factory.
FAQ:1. When barrier finish closing, why does the arm open itself
slowly?- the spring is too tight, you need release the spring a little, then
test it again.
- see whether the main crank touch the triangle tightly or not, if
tightly, adjust it.
- reset the balance position and the electrical limit switch.
2. Why does the controller panel operate with "Di Di Di" abnormal
noises?
- As for this, it means the resistance on controller board is broken,
if you have professional tools to check,
- then replace that broken resistance, if not, replace that
controller panel.
3. Why does the barrier finish half operation of opening and
closing?
- If uses our controller panel, you only need to find resistance R37
on controller panel, and repalce it is ok.
4. When barrier closed, why is there a 5 degree angle of
inclination?
- the model is not good, and the gear doesn't fit each other tightly.
- the barrier didn't adjust well, need to reset.
5. When barrier finish open, but it closes itself without any order
control, what's the problem?
- To check the loop cable first, because the loop cable maybe brokem
- To check the motor sensor, if it is not set well, then reset it in
the middle between two holes on sensor rod.
6. Why does the arm wave a lot when opening and closing?
- The spring is very tight
- The Screw touches the rubber absorption tightly, need to reset
again.
7. Rubber linning installation suggestion:
- It is good use for fast speed, like 0.6s, 1s, 1.8s and 3s.
- The place with many vehicles come and go, like shopping center,
carpark area.
8. Can you accept OEM/ODM order?
- Absolutely, we are manufacturer of barrier gate, with 7 years
researching and developing experience.
