Rotary Vibrating Screen is a high-precision powder griddle, low
noise, high efficiency, quick changer takes 3-5 minutes, totally
enclosed structure, for grain, flour, mucus and other materials
screening filter. Rotary Vibrating Screen is a motor for vertical
excitation source, the motor and lower eccentric weight installed
at both ends of the motor rotary motion into a horizontal,
vertical, inclined three elementary motions, then the movement
passed to the screen surface . Adjust the upper and lower ends of
the phase angle, the material can change the trajectory of the
screen surface.
Application:
The product is applicable to any powder, granule, liquid screening
and filtering of the industry. SY series rotary vibration screen is
widely used in chemical industry, medicine powder, liquid, paint,
pigments, cosmetics, oil, resin, ceramic slurry, clay slurry, lime,
refractory powder at the end, magnetic powder, polishing powder,
fruit juice, beverage, sugar, salt, MSG, spices, milk powder,
starch, flour, rice flour, carbon powder, graphite powder,
manganese powder, lithium carbonate, help solvents, fire
extinguishing agents, as well as the environmental protection
industry wastewater, wastewater treatment process of screening,
filtering.
Use and maintenance
1, the machine shall be equipped with electrical protection device.
2, the machine is running early, check every day at least once a
bolt to prevent loosening.
3, when the motor direction of rotation does not meet the
requirements, you can adjust the power supply phase sequence.
4, the motor should guarantee good lubrication, each running about
two weeks to add lithium grease once, come on, through the oil by
adding appropriate amount of lithium grease cup. When using sealed
bearings, the motor is not installed on the oil cup.
5, the machine running total of 1500 hours, check the bearings, if
serious injury should be immediately replaced.
6, the machine parked or garaged when used again after a long time,
measure the insulation resistance should be used to measure
500-volt megger, should be greater than 0.5 MΩ.
