ABB Module IMDSI14 ABB IMDS-I14 ABB IMDS I14 Digital Input Module
12 month warranty
Product Description:
The overflow numerical value of +32767. If the measured value is
below the range, the underflow numerical value of -32767 is set.
The input impedance is ca. 330 Ω. The current input has
a self-protecting mechanism. If the input current gets too high,
the shunt is switched off and the value for range overflow is
generated. About every second, the unit tries to switch on the
shunt again. In this way the correct measurement will succeed after
the current has reached a normal value again.
The trigger of the self-protecting mechanism is displayed by the
red LED Ovl as long as the overload is present. In the PLC system
an error message is then stored (FK4, error number 4).
Related Product Recommendation:
| 07AI91C | 7KT97C | DSMB114 57360001-MG |
| TB511-ETH | 07KT97D | DSMB116 5736 0001-EB |
| PM581B1 | 07KT97B | DSMB144 57360001-EL |
| TU516 TU516A | 07KT97C | DSMB151 57360001-K |
| DI524 | 07KT97 | DSMB176 57960001-HX |
| AX522A | 07KT97B | DSMC110 57330001-N |
| AI523 AI523B4 | 07KT97B | DSPC155 57310001-CX |
| 86AR230 | 07KT97B | DSPC172H 57310001-MP |
| 07KR91B | 07KT97B | DSQC 352A |
| 07SK90R1 | 07KT98E2 | DSQC 539 3HAC14265-1 |
| 23KT92 RTU510 | 07MK92 | DSQC 633A 3HAC031851-001 |
| 07DO90-S | TC50 | DSQC104 6369901-104 |
| 07KP90 | ICFC16l1 | DSQC201 YB560103-AB |
| 07DC91 | ICSF08D1 | DSQC205 YB560103-AD/1 |
| 07DC91 | ICSK20F1-120 | DSQC223 YB560103-BD |
| 07MK92 | ICSK20F1-230 | DSQC227 YB560103-BK |
| 07KT94 | ICSK20F1-24 | DSQC236G YB560103-CD |
| 07KT94D | ICSK20N1 | DSQC236T YB560103-CE |
| 07KT94K | ICSA04B5 | DSQC239 YB560103-CH |
| 07KT94i | ICSE08B5 | DSQC325 3HAB2241-1 |
| 07KT94 | 07KR31 | DSQC328A 3HAC17970-1 |
| 07DC92 | 07KR31 | DSQC332 3HAB9669-1 |
| 07DC92E | 07KT31 | DSQC334 3HAB5845-1 |
| 07DC92F | 07MK62 | DSQC335 3HAB6182-1 |
| 07DC92B | 35NE90 | DSQC345B 3HAB8101-2 |
| 07AC91 | 35GS91 | DSQC346G 3HAB8101-8 |
| 07DI92 | 35GS91 | DSQC354 3HNE00065-1 |
Product's Character:
The following figure shows the connection of a 3-wire sensor
powered by 24 V DC and of a 2-pole sensor powered electrically
isolated. Both sensors work as active current sources 0...20 mA.
It has to be taken into consideration, that in this application the
M terminal of the basic unit 07 KT 94 is
the reference potential. AGND1 is not dimensioned for carrying the
sum of the sensor currents.Differential inputs are very useful, if
analog sensors are used which are remotely non-isolated (e.g. the
minus terminal is remotely earthed). Since the earthing potential
is not exactly the same as
AGND1, it has to be measured bipolar in order to compensate
measuring errors. Additionally, in case of singlepole
configuration, AGND1 would be connected directly to the remote
earth potential. This would cause inadmissable (and possibly
dangerous) earthing loops. In all configurations using differential
inputs two adjacent analog inputs belong together (e.g. EW 6,00 and
EW 6,01). For configuration, both inputs must be configured for the
desired operating mode, see configuration table Fig.
LOT 6 NEW HUBBELL ASSORTED HBL9330 HBL5661 HBL2620 RECEPTACLE PLUG
B250164
LOT 2 NEW GATES ASSORTED B50 RBL 53IN X 21/32IN V-BELT B364939
LOT 3 NEW SQUARE D B1.30 THERMAL OVERLOAD HEATER ELEMENT D274464
LOT 28 NEW 2IN IRON 45-DEGREE ELBOW CONDUIT FITTING ASSORTED
D239291
NEW CATERPILLAR CAT 9W-9940 MOUNT ASSEMBLY MACHINE REPLACEMENT PART
B488037
LOT 2 NEW NERCON HBB7689L ADJUSTING NUT 7/8IN THREAD D362288
LOT 2 NEW TSUBAKI RS100 SINGLE CHAIN CONNECTING OFFSET LINK B381266
LOT 8 CALAMO NORDS DN65 76.1 2-1/2IN STAINLESS CLAMP B373011
LOT 10 NEW TNA TNA-E2301-1 CONNECTOR ELECTRICAL MALE BRASS D233387
NEW 8-1/4IN LENGTH 3-9/16IN OD 10MM WIRE COMPRESSION SPRING D439199
LOT 5 THOMAS&BETTS 2556 1-1/4IN STRAIN RELIEF CORD CONNECTOR
STRAIGHT B202910
LOT 2 NEW GATES AX70 TRI POWER 72X1/2IN TIMING BELT B272774
The use of the product:
1.tobacco,
2.petrochemical,
3. transmission and distribution. SHIDE
Product's advantages:
1.We keep more than 10 thousands Transistors in warehouse, it could
cut lead time of most items.
2.Experienced technichal support team.
3.365 days warranty for all the goods from us.
Our advantages:
1. Customer service in 1-4 hours. If there's any question, please
contact with our sales.
2. new and original
3.1 year warranty
Frequently Asked Questions:
1. Q: Do you provide warranty for the goods?
A: Yes, we provide warranty for all the goods from us.
2. Q: Could Moore provide technology support?
A: We're in this field more than 12 years. If there's any problem,
please contact with us,we'll provide suggestion from our engineer
to help you solve problem.
3. Q: Does Moore keeps goods in stock or only trading?
A: We have large warehouse for goods. Keep lots of goods in
warehouse, so could promise fast delivery.
Send your Inquiry details in the Below, Click "Send" Now!
Contact Information:
Contact:Miya ( manager)
Email :sales@mooreplc.com
Q Q: 2851195450
Skype: miyazheng520
Mobile:86-18020776792 ( what's app )
