RS485 Communication Interface Traffic Barrier Gate with 50 Meters
Remote Comtroller
Quick Detail:
Name: Traffic Barrier Gate
Speed:6 seconds
Feature:Straight boom
Rated Power:80W
Certificate:CE, ISO, SGS
Arm type: Straight arm, folding arm, fence arm, optional
Arm length: Max 6 meter with aluminum alloy
Rating voltage: AC 220/110V±10%, 50/60HZ
Functions & Features
a: Boom backtrack function:
The boom will rise up if it comes across obstacles when falling.
And it will stop if it hits something when rising.
b: Infrared photocell function:
If the infrared signal is cut off when the boom is falling, the
boom will rise up automatically.
c: R&G light terminal:
The light will turn green only when the boom is at the vertical
position. Red light is for other positions.
d: Loop detector terminal:
If the vehicles detector is installed correctly, the boom will
automatically rise up when there is some press of the vehicle on
the loop. and it iwll automatically fall after the vehicles leaves
the loop.
e: Spring installation, Spring relacement
Spring relacement as follows: The Barrier Gate lever to 90 degrees,
the door status
1. Spring balance relacement adjustment screw with a hex wrench
M88x140mm
2. Use a wrench to relacement the lower spring hanging scroll of a
M10 screw: If you do not take a spring hook M10 screw, you can
directly relacement the spring. Installation procedure is just the
opposite of relacement.
Specifications
Model | WST1211 |
Working Temperature | -40℃～+75℃ |
Voltage | 220V±10%, 110V±10%, 50/60HZ |
Rated power | 80W |
Relative humidity | ≤90% |
Remote control distance | ≥30m |
Net weight | 48kgs |
Speed | 1S,1.8S,3S, 6S |
Max boom length | 6 meters |
Motor Rotational speed | 1400rmp |
Protection Degree | IP44 |
Communication with customers
A: Barrier gate controllling:
There are three buttons to control the barrier gate conveniently
when the barrier gate sets well.
If the boom can not fall down or rise up to the right position, or
rises up automatically after reaching the horizontal position,
please check whether the abnormal situation is caused by loop
detector or not.
If the abnormal situation mentioned above is not causeed by loop
detector, please check the"Gate Type Selection " setting.(Note: the
barrier gate speed has been fixed. and this "Gate Type Selection"
is just for controller adjustment to keep its' working speed accord
with the barrier gate speed) The " Gate Type Selection has been
well set before leaving our factory, but user can adjust it if
needed.
