I2C Controlled Starter Kit for Arduino , Rfid Stepper Motor
Learning Kits
Quick Details:
1.1602 screen for 1602, I2C control more convenient,
2. High quality and large bread board
3. The DS1302 clock module has been added,
4. A new voice detection module,
5. Temperature humidity module has been added,
6. Stepper motor driver board
Product Desctription:
The Uno for Arduino is a microcontroller board based on the
ATmega328 . It has 14 digital input/output pins (of which 6 can be
used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator,
a USB connection, a power jack, an ICSP header, and a reset button.
It contains everything needed to support the microcontroller;
simply connect it to a computer with a USB cable or power it with a
AC-to DC adapter or battery to get started.
The Uno differs from all preceding boards in that it does not use
the FTDI USB-to-serial driver chip. Instead, it features the
Atmega16U2 (Atmega8U2 up to version R2) programmed as a
USB-to-serial converter.
Revision 2 of the Uno board has a resistor pulling the 8U2 HWB line
to ground, making it easier to put into DFU mode.
RFID for ARDUINO learning packages using UNO R3 for ARDUINO this
latest control panel,
The microcontroller allows users to learn from the boring when
theoretical knowledge,
In the play in the development of the ability to obtain RFID SCM
system.
Product List:
| Microcontroller | ATmega328 |
| Operating Voltage | 5V |
| Input Voltage (recommended) | 7-12V |
| Input Voltage (limits) | 6-20V |
| Digital I/O Pins | 14 (of which 6 provide PWM output) |
| Analog Input Pins | 6 |
| DC Current per I/O Pin | 40 mA |
| DC Current for 3.3V Pin | 50 mA |
| Flash Memory | 32 KB (ATmega328) of which 0.5 KB used by bootloader |
| SRAM | 2 KB (ATmega328) |
| EEPROM | 1 KB (ATmega328) |
| Clock Speed | 16 MHz |
Product Photos:
