Hot Runner Electric Coil Heater with K Type Thermocouple
1. Coil Heater Brief Introduction
Wuhan Global Metal Hot Runner Electric Coil Heater with K Type
Thermocouple use Germany heater wire,
United States high purity magnesium oxide material, and strict
process technology. There are various cross
section and size for choice, such as square, round and flat,
provide high performance electric heater for
heating hot runner mold and other fields.
Heater maximum temperature up to 650 ºC, the integration of
temperature thermocouple for the precise
temperature control, can provide K, J, E thermocouple, blasting and
blackening surface treatment, also can
provide bright surface.
2. Coil Heater Application
This electric coil Heater is widely applied for hot runner system,
plastic industry, packaging machinery, medical
equipment, casting process,other electric heating industry, etc..
3. Coil Heater Characteristics
a. The inside insulated cover, same as the German GC.
b. Very good performance of the heating uniformity in the heating
area.
c. High insulation (more than 500M ohm) and high pressure
resistance (1000V above), can meet special
requirement if customers need.
d. The moisture-proof can be IP65, suitable for working in bad
condition.
4. Coil Heater Parameter.
Standard Configuration
- Material : 304
- Unheated length(L1): 45mm
- Connector(cold side)(DxU):
- Square cross-section: Ф7.6x26mm
- Round flat cross-section: Φ7.5x29mm,Φ3.5x40mm
- Power lines,grounding wire length(L): 1000mm
- Jacket:Silicone fiberglass sheathing establishment,black and others
- Thermocouple: J tpye
- Compensating lead wire length(L): 1000mm
- Surface treatment: sandblasting,black, polish
Electric coil heater (H series) | 3.0x3.0
3.3x3.3
4.0x2.0
4.2x2.2
4.5x2.7 | Φ3.0 | Φ4.0 | Φ5.0 | 3.5x3.5
4.0x4.0 | 5.0x5.0 |
Voltage | 220V,230V,240V |
Power tolerance 115W-200W | +/-10% |
Power tolerance 201W-2000W | +5%-10% |
Out jacket length | 30mm~280mm |
Diameter of the inner sleeve/wrapped diameter | 10mm~42mm |
Unheating length | 45mm |
Max power density | 9W/cm² |
Heating Length tolerance | +/-0.05mm |
Unheating length tolerance | +/-2.5% |
Tolerance ID d ≤20mm | Without inner sleeve:-0.15mm
With inner sleeve:0.05mm~0.10mm |
Tolerance ID d 20mm~30mm | Without inner sleeve:-0.20mm
With inner sleeve:0.05mm~0.10mm |
Tolerance ID d ≥30mm | Without inner sleeve:-0.25mm
With inner sleeve:0.05mm~0.10mm |
Tolerance cross section | +/-0.15mm | +/-0.20mm |
Thermocouple | K,J,E | None |
Material | 304,321,316 |
Maximum working temperature | 650℃ |
Die electrical strength | 800V | 1000V |
