Auto Inflator Fire Mechanism Device With 1/2 " Thread For Automatic
Gas Life Jacket
Descripation:
The lifejacket inflator is a robust, compact unit used in leisure
and commercial activities. The unit offers both manual and
automatic inflation facilities, with dual status indication
confirming that the inflator has been activated. The product is
approved in accordance with the EN standard requirement for
lifejackets.
On entering the water, automatic activation of the unit usually
takes less than 1 second and the re-charging procedure is quick and
simple.
The units are available on demand, with re-charge kits being
stocked by most distributors of marine products.
Installation Advice:
The auto inflator should be assemble with water activate bobbin
correctly, screw tight, and connect to the brass valve base tight
to ensure gas will not leak. and screw on the CO2 cylinder.
Material/ component:
High Quality Nylon Plastic, Pin, green indication clip, pull cord,
Good quality Spring.
Standard:
ISO12402-7
Corrosion resistence;
UV Protection
Detail component in our inflation system:
| Name | Qantity |
| Automatic device | 1 |
| Oral Tube | 1 |
| Brass Air valve | 1 |
| Water Activate Bobbin | 1 |
| Co2 Cylinder | 1 |
Storage condition:
it should be installed tightly on the life jackets
Reusable
Thread
Thread Specification: 1/2" & 3/8"
Thread Material: Brass or Plastic
Pull Cord:
Length:10cm, 15cm, 25cm, 30cm or customerized
Handle type: round handle, sea anchor handle
Tips:
If you have any need and questions,pls feel to contact with me
about the manual and automatic inflator device for inflatable life
jacket/vest accessories
