3 Ton Fast Speed Diesel Engine Cable Pulling and Hoisting Winch
Machine
Brief Introduction
It is set up high-voltage transmission lines and laying of aerial
construction machinery underground cables, smooth, convenient for
Tower Group legislature, set up guide (land) lines, lifting,
pulling in a variety of complex conditions.
Widely used in electricity, telecommunications line construction
group established tower, mobile actinomycetes, tight line, also in
place lifting and construction, docks and other traction weights,
suitable for field sites without electricity, using handy.
The experiments and field practice has proved that with a
reasonable structure, small size, light weight, utilitarian large,
flexible operation, easy handling, etc., the majority of electric
power, telecommunications operators welcome.
Brake System
Automatic clamp brake and clutch brake transmission interlock two
brakes are braking action in positive and negative directions.
Maintenance and safe use
1. Engine use and maintenance, according to the machine
instructions.
2. Lifting shall not exceed in line with use.
Lubricating oil surface must be kept within 1/4
3. gearbox, before using the machineoutside the bearing should add
oil.
4. Automatic burning cars and interlock brakes, should always pay
attention to the wear of the friction plate, the automatic braking
gear and back tighten loose gap of 0.5mm, if the gap is greater
than 1.5 mm, you must replace the friction plate, or likely to
cause accidents.
5. Automatic brake load the gearbox, automatic normal lifting, due
to the reverse gearis stuck, there is no "beep beep" sound when the
back loose.
6. The bearing support frame is anchored on both sides of the reel
anchor point, it can not be used as an anchor point to another
location.
7. After the long-distance transport aircraft, before use, must be
a detailed examination of the various components fastening screws
loose, ministries parts is stagnant leak.Gearbox ZL4 aluminum body
with screws on it should not be too tight and
unnecessarydisassembly, but can not use a hammer.
Specifications
| Model NO. | Gear | Rated Pulling Force(KN) | Pulling Speed(m/min) | power |
| JM3B | slow | 15 | 12.5 | diesel engine |
| quick | 9 | 24 |
| reverse | No lifting | 11.5
|
Test before delivery
