| Function module | Operation |
|---|
| X-ray tube control | Using mouse to click the X button can turn on or off the X-ray. The
real-time tube voltage and current value will display beside, users
can click up and down button, or drag the slider, or type to
adjust. |
| Status bar | Indicates the interlock status, pre-heat status, and X-ray status
by flashing alternately red and green. |
| Image effect adjustment | The brightness, contrast and gain of the image can be adjusted
freely to achieve a satisfactory result. |
| Product list | Users can save the inspection parameters such as Z-axis position,
brightness, contrast and gain, and can directly call the parameters
when inspecting the same product, to improve the inspection
efficiency. |
| Navigation window | After the camera takes a photo of the table, click anywhere in the
photo, the table will move to the place you click and display on
the screen. |
| Motion axis status | Display real-time coordinates. |
| Inspection result | The measurement results (voids rate, distance, area, etc., set by
users) display in order. |
| Speed control | The movement speed of each axis can be adjusted to slow, normal and
fast. |
| Voids rate measurement |
|---|
| Automatic calculation | Click on two points to determine a rectangle. The software
automatically finds and measures the edge of the solder ball in the
rectangle, the pad and the internal voids, and can get the data of
the voids rate, the area of the solder ball, the circumference, the
biggest void's rate, the length and the width, and indicates NG or
OK by red and green. |
| Parameters adjustment | Users can adjust the grayscale threshold, pixel, contrast, size
filtering and other parameters to get accurate results of automatic
calculation. |
| Add voids manually | Users can draw a polygon or a free figure and calculate it as a
void into the void rate. |
| Save parameters | Users can save parameters such as grayscale threshold, pixel,
contrast, size filtering and other parameters, and can directly
call the parameters when detecting the same product, to improve the
detection efficiency. |
| Other measurement function |
|---|
| Distance | Click the A and B points to set as the baseline, then click the C
point to measure the vertical distance from the C point to the
baseline. |
| Distance rate | It is mostly used to measure the soldering rate of the
through-hole. Set one more point "D" than the distance. Divide the
vertical distance from the D point to baseline by the vertical
distance of the C point, to obtain the percentage ratio of the
vertical distance of D to C. |
| Angle | Click the A and B points to set as the baseline, then click the C
point to measure the angle between the BA and BC rays. |
| Radius | It is mostly used to measure round components such as solder balls.
Click three points to determine a circle and measure the
circumference, area and radius. |
| Perimeter | It is mostly used to measure square components, click two points to
determine a square, measure the length, width and area. |
| Automatic inspection |
|---|
| Manual setting | Users can set any positions on the table as inspection points, the
software will automatically inspect and save the picture. |
| Array | For the regular inspection points, users only need to set two of
the inspection points and the number of rows and columns, the
software will automatically inspect each point and save pictures. |
| Automatic identification | For inspection points with obvious features, the software
automatically identifies the positions, takes measurements, and
saves the image. |
