Functibn
module | Operation | Keyboard and mouse can finish all operations |
X-ray tube
control | Using mouse to click theX button can turn on or off
the X-ray.The real-time tube voltage and current
value will display beside,users can click up and
down button,or drag the slider,or type to adjust. |
| Status bar | Indicates the interlock status,pre-heat status,and
X-ray status by flashing alternately red and green. |
Imageeffec
adjustment | The brightnesscontrast and gain of the image can
be adjusted freely to achieve a satisfadory result. |
| Product list | Users can save the inspection parameters such as
Z-axis position,brightness,contrast and gain,and
can directlycall the parameters when inspecting the
same product,to improve the inspection efficiency. |
Navigation
window | After the camera takes a photo of the table,click
anywhere in the photo,the table willmove to the
place you click and display on the screen. |
| Motion axis status | Display real-time coordinates. |
| nspection result | The measurement results(voids rate,distance,
area,etc.,set by users)display in order. |
| Speed control | The movement speed of each axis can be adjusted
to slow,nomal and fast. |
Voids rate
measurement | Automatic
calculation | Click on two points to determine a rectangle.The
software automatically finds and measures the
edge of the solder ball in the rectangle,the pad and
the internal voids,and can get the data of the voids
rate,the area of the solder ball,the circumference,
the biggestvoid's rate,the length and the width,and
indicates NG or OK by redand green |
Parameters
adjustment | Users can adjust the grayscale threshold,pixel,
contrast,size fiterng and other parameters to get
accurate results of automatic calculation. |
Add voids
manually | Users can draw a polygon or a free figure and
calculate it as a void into the void rate. |
Save
parameters | Users can save parameters such as grayscale
threshold, pixel, contrast, size filtering and other
parameters, and can directly call the parameters
when detecting the same product, to improve the
detection efficiency. |
Other
measurement
function | Distance | Click the A and B points to set as the baseline, then
click the C point to measure the vertical distance
from the C point to the baseline. |
| Distance rate | It is mostly used to measure the soldering rate of
the through-hole. Set one more point “D” than the
distance. Divide the vertical distance from the D
point to baseline by the vertical distance of the C
point, to obtain the percentage ratio of the vertical
distance of D to C. |
| Angle | Click the A and B points to set as the baseline, then
click the C point to measure the angle between the
BA and BC rays. |
| Radius | It is mostly used to measure round components
such as solder balls. Click three points to determine
a circle and measure the circumference, area and
radius. |
| Perimeter | It is mostly used to measure square components,
click two points to determine a square, measure the
length, width and area |
Automatic
inspection | Manual setting | Users can set any positions on the table as
inspection points, the software will automatically
inspect and save the picture |
| Array | For the regular inspection points, users only need
to set two of the inspection points and the number
of rows and columns, the software will automatically
inspect each point and save pictures |
Automatic
identification | For inspection points with obvious features, the
software automatically identifies the positions,
takes measurements, and saves the image. |
