Operation Module
Keyboard and mouse can finish all operations
X-ray Tube Control
Using mouse to click the X button can turn on or off the X-ray. The
real-time tube voltage and current value will display beside, users
can click up and down button, or drag the slider, or type to
adjust.
Status Bar
Indicates the interlock status, pre-heat status, and X-ray status
by flashing alternately red and green.
Image Effect Adjustment
The brightness, contrast and gain of the image can be adjusted
freely to achieve a satisfactory result.
Product List
Users can save the inspection parameters such as Z-axis position,
brightness, contrast and gain, and can directly call the parameters
when inspecting the same product, to improve the inspection
efficiency.
Navigation Window
After the camera takes a photo of the table, click anywhere in the
photo, the table will move to the place you click and display on
the screen.
Motion Axis Status
Display real-time coordinates.
Inspection Result
The measurement results (voids rate, distance, area, etc., set by
users) display in order.
Speed Control
The movement speed of each axis can be adjusted to slow, normal and
fast.
Voids Rate Measurement
Automatic calculation: Click on two points to determine a
rectangle. The software automatically finds and measures the edge
of the solder ball in the rectangle, the pad and the internal
voids, and can get the data of the voids rate, the area of the
solder ball, the circumference, the biggest void's rate, the length
and the width, and indicates NG or OK by red and green.
Parameters Adjustment
Users can adjust the grayscale threshold, pixel, contrast, size
filtering and other parameters to get accurate results of automatic
calculation.
Add Voids Manually
Users can draw a polygon or a free figure and calculate it as a
void into the void rate.
Save Parameters
Users can save parameters such as grayscale threshold, pixel,
contrast, size filtering and other parameters, and can directly
call the parameters when detecting the same product, to improve the
detection efficiency.
| Function | Description |
|---|
| Distance | Click the A and B points to set as the baseline, then click the C
point to measure the vertical distance from the C point to the
baseline. |
| Distance Rate | Mostly used to measure the soldering rate of the through-hole. Set
one more point "D" than the distance. Divide the vertical distance
from the D point to baseline by the vertical distance of the C
point, to obtain the percentage ratio of the vertical distance of D
to C. |
| Angle | Click the A and B points to set as the baseline, then click the C
point to measure the angle between the BA and BC rays. |
| Perimeter | Mostly used to measure square components, click two points to
determine a square, measure the length, width and area. |
| Radius | Mostly used to measure round components such as solder balls. Click
three points to determine a circle and measure the circumference,
area and radius. |
