WESPC Original Smartgen HGM180HC Start Engine Generator Controller
Control Panel
| Size | 100*100*50mm |
| Weight | 0.4kg |
| Model Number | HGM180HC |
| Brand Name | Smartgen |
| Product Name | Engine Generator Controller |
| Application | diesel generator |
Technical Parameters:
Display LED
Digital Input 4
Alternator Frequency 50/60Hz
DC Supply DC(8～35)V
Case Dimensions(mm) 84*72*35
Panel Cutout(mm) 78*66
Operating Temp. (-30~+70)℃
Product Overview:
The Model 180/180hc is an Automatic Engine Control Module. The
module is used to automatically start and stop the engine,
indicating the operational status and fault conditions,
automatically shutting down the engine and indicating the engine
failure by LED on the front panel.
HGM180hc append a LCD hours count that base on HGM180.
Operation:
If you use hgm180 for the first time , configure is necessary. If
you want to configure the module ,please look Configuration.
Operation of the module is via a three position key switch mounted
on the front panel with OFF(O), STARTand AUTO positions. In the ‘O’
position the output are de-energized.
Manual Operation:
1. Select manual run
2. Depress pre-heat button for required length of time
3. Press START to crank engine
Once the Start button is pressed and maintained, the engine fuel
system is energized. The ‘Crank’ output is then energized and the
starter motor operated, disengaging automatically when the engine
fires or when the ‘Start’ button is released. The protection
hold-off timer is then initiated.
Automatic Operation:
1. Select AUTO
2. When Remote Start is active, the generator will automatic start.
Operation of any of the following alarms (which are close on fault)
will cause the run output to de-energize:
. Low Oil Pressure
. High Engine Temperature
. Auxiliary Shutdown
. Over speed
This will remove the fuel supply from the engine and bring it to
rest. Each alarm has its own LED indicator and once activated no
further alarm conditions will be accepted. The alarm output and
relevant LED will remain active until the unit is reset by turning
the switch to the ‘O’ position.
Over speed Protection:
Over speed protection is derived from the generator Hz output. The
over frequency circuit monitors the generator Hz output and will
shut down the engine immediately if a pre-set frequency level is
exceeded. This trip level is selected by a switch for either 50Hz
or 60Hz nominal operation (57Hz or 68Hz trip respectively).
During engine cranking and for a short time afterwards the
protection hold-off timer (10 seconds) is active and the relevant
alarm inputs are inhibited. This enables the engine to start and
achieve normal running conditions. Once the timer has expired the
inputs are enabled providing normal protection from the module.
Charge Failure warning:
Charge Failure warning is also provided by monitoring the WL
terminal on the charge alternator. This operates on a similar
principal to the warning lamp fitted in a motor vehicle, should the
output fail the charge fail LED will illuminate. The module will
also provide the alternator excitation current via this connection.
SPECIFICATION:
DC Supply: 8 to 35 V Continuous.
Alternator Input Range: 15 - 306VAC(+20%) RMS
Alternator Input Frequency: 50 - 60 Hz at rated engine speed.
Over speed: nominal frequency +14% (+24% Overshoot)
Start Output: Solid State 1A positive B+ terminal
Fuel Output: Solid State 1A positive B+ terminal
