Air inlet system:
The 1104D-E44TAG engine is equipped with a fully-mounted,
replaceable dry-element air filter and a wastegated turbocharger,
both pre-assembled on the engine to ensure clean, pressurised
induction for optimum combustion and minimal maintenance downtime
Fuel system:
A common-rail electronic governing system meets ISO 8528-5 Class G3
requirements while a next-generation spin-on fuel filter with
integral water separator and manual priming pump combine to protect
injectors and maintain steady fuel delivery under variable load
Lubrication system:
A cast-aluminium wet-sump pan with filler neck and calibrated
dipstick holds 8.4 L of oil, and a full-flow spin-on canister oil
filter is mounted on the offside of the block for quick roadside
servicing and extended 500-hour service intervals
Cooling system:
A thermostatically-controlled water-cooling circuit uses a
gear-driven circulation pump and a 22-inch belt-driven pusher fan
mounted behind a high-capacity radiator that incorporates an
air-to-air charge cooler; all plumbing, guards and mounting
brackets are factory-attached for immediate drop-in installation
Electrical equipment:
A 12-volt negative-earth electrical system includes a pre-engaged
starter motor, a 12-volt 65-amp alternator with DC output, and a
12-volt energise-to-run shutdown solenoid, all wired to a single
customer interface plug for rapid connection to generator control
panels
Flywheel and housing:
A high-inertia flywheel machined to SAE J620 size 10/11½ is bolted
to the crankshaft and enclosed by an SAE 3 flywheel housing,
providing compatibility with standard industrial clutches and
close-coupled alternator adaptors
Mountings:
A robust front engine mounting bracket is cast integrally with the
timing case, allowing direct attachment to skid or base-frame rails
without additional fabrication and ensuring rigid support during
operation
