1150Ordm C Heat Treatment Electric CIM MIM Sintering Furnace For Metalworking

1150°C HWF260-11NH Electric Elevator Furnace CIM/MIM Annealing Degreasing Tank Furnace for Metalworking

Brazing, annealing, CIM/MIM (Compression Injection Molding/Metal Injection Molding), degreasing, degassing, drying, pyrolysis, quenching, rapid prototyping, sintering, welding, sublimation, synthesis, tempering, and other processes.

• Rated Temp.: 1100°C
• Max Temp.: 1150°C
• Effective Dimensions: Φ550×1100mm(d×H)
• Heating Method: FEC ceramic fiber heater
• Thermocouple: N-Type
• Temp. Set Accuracy: ±1°C
• Temp. Control Mode: Japanese Programmable Temperature Controller with PID auto-tuning
• Temp. Uniformity: ±5°C
• Maximum Heating Power: 54kW
• Insulation Power: ≤25kW
• Operating Atmosphere: Air/N2/H2
• Heating rate: ≤5°C/min
• Surface temperature rise: ≤35°C
• Temperature control points: 3 independently controlled zones (upper, middle, lower)
• Cooling method: Forced cooling via external blower
• External Dimensions: 2100×3900×2500mm(W×H×D)
• Appearance Color: Light gray

• Environmental Conditions: temperature: 0~40°C, humidity≤80%RH, no corrosive gas, no strong airflow disturbance
• Nitrogen gas conditions: Supply pressure 0.2-0.4 MPa; purity ≥99.999%; consumption 3-7 m³/h
• Hydrogen gas conditions: Supply pressure 0.2-0.4 MPa; consumption 3-7 m³/h
• Air conditions: Supply pressure 0.2-0.4 MPa; clean, dry, oil-free; consumption 3-7 m³/h
• Water inlet conditions: 0.1-0.3 MPa; clean, non-corrosive; supply flow rate 1-3 L/min
• Ventilation system: Non-contact interface with user exhaust system; extraction capacity >10 m³/h
• Ground Requirements: horizontal, no obvious vibration, load-bearing>500 Kg/m²
• Power Condition: capacity >75kVA, 3-phases 5-lines, voltage 220/380V, frequency 50Hz
• Installation Site: 3500mm×3000mm×5000mm(D×W×H), with an installation area greater than 10m²