DESCRIPTION
The JaourTak ® is a synthetic rubber based hot melt pressure
sensitive adhesive specifically developed for on line labeling for
PET bottles. It is water white transparent in color. The product is
featured high tack and peel, good wetting to substrates, no
flagging after ageing, good machinability and non-stringing,
excelent pot and ageing stability.
SUGGESTED USES
On line labeling for PET bottles.
TYPICAL PROPERTIES
| Appearance | Water white transparent solid |
| Color (Gardner) | ≤ G1 |
| Softening Point (R&B) | approx. 72°C |
| Viscosity (Brookfield) | |
| @110 ° C | approx. 2,600 cps |
| @120 ° C | approx. 1,600 cps |
| @130 ° C | approx. 1,000 cps |
| @140 ° C | approx. 800 cps |
OPERATING GUIDES
The material can be applied by slot or roll coating applicators.
Suggested operation temperature is 110 – 140 °C for both, depending
on machines, substrates, and plant conditions.
FDA STATUS
The product complies with the FDA Indirect Food Contact Regulation
of 21 CFR 175.105, “Adhesives”.
PACKAGE
1kg block wrapped with siliconized release paper, 20kg/box; or,
1.04kg block wrapped with siliconized release
paper, 25kg/box.
Please consult the sales representative for special requirements.
STORAGE & SHELF LIFE
The intact packing material can be stored indoor for 24 months,
from the date of manufacture, in its original packages under dry
and clean conditions at ambient temperature below 35 0°C and above
5 °C. Direct sunlight and moisture condensation must be prevented.
OPERATING PRECAUTIONS
Do not mix with other adhesives to prevent contamination. The
material is applied hot. Appropriate personal protective clothing
and eye protection are strongly recommended to prevent burns.
Adequate ventilation is suggested to remove any vapors or fumes
generated. Rotate stocks and using the oldest stock first.
