① When the ON button is used as the code match button, the code
matching steps are as follows
1) First of all, connect the intelligent receiver to the lamp, then
connect the intelligent receiver to the power supply, and then
power on the power supply;
2) Press the ON button, the pressing duration is longer than 1S, if
the lamp will blink 3 times, then the code match is successful, the
panel controller can control the controller;
3) If the matching fails, repeat Step 1 and Step 2；
② When the ON button is used as the code study button: If you need
multiple remote controls to control an intelligent receiver at the
same time, the remote controls need to learn their code values
between each other, remote control A can already control A receiver
through the code, remote control B and remote control A control the
receiver at the same time, remote control B only need to learn the
code value of remote control A, the steps are as follows:
1) Press the ON button of remote control B for more than 10S. At
this time, remote control B enters the code learning mode, remote
control B will accordingly control a group and the blue light of
remote control B should be steady 30S. (Remote control B can exit
the code learning mode by pressing the clear code key.)；
2) Then press the code matching key of remote control A for more
than 1S. If the blue light of the corresponding group of remote
control B blinks three times, remote control B learns the code
value code of remote control A successfully, and remote control B
can control the receiver；
3) If remote control B fails to learn the code, repeat steps 1 to 2
until it succeeds；
③ When the OFF button works as a code clear key, the code clearing
procedure is as follows:
1) When the OFF button is pressed for more than 10S, the blue light
corresponding to the remote control group blinks 3 times, the
remote control code value changes, and the clear code becomes work；
2) After the code clearing is successful, the remote control no
longer controls the receiver；
3) If the code clearing fails, repeat steps 1 to 2 until it
succeeds.
④ When the OFF works as an internet transfer key, the procedure is
as follows:
1) First to match the code to make sure that the panel can control
the receiver with wireless module;
2) When the OFF button is pressed for more than 10S, the lamp of
the receiver with wireless module flashes for 3 times;
3) If the network transfer is successful, the receiver can be
reconfigured.
