Spare and wear part V3560170-0100 V3568985-0100 for ALSTOM OPTIPULS
Pulse valve V2549810-0300 V2549810-0400
Diaphragm code : V3560170-0100 ,max.90°C fitted for ALSTOM OPTIPULS
Pulse valve V2549810-0300
Diaphragm code : V3568985-0100 ,max.120°C fitted for ALSTOM
OPTIPULS Pulse valve V2549810-0400
1 . The design with integral compression fittings will facilitate
installation because there is no need for threaded piping
2 . The high quality diaphragms are reinforced and wear resistant
to guarantee a long operating life, even under harsh conditions
3 . Integral pilot operated valves satisfy all relevant EC
directives
4 . The pulse diaphragm valves are especially designed for dust
collector service applications, combining high flow, long life and
extremely fast opening and closing to produce reliable and
economical operation.
5 . The high flow, angle type bodies in combination with the
special main diaphragm assemblies give the unique operating
features required for dust collector service applications
Competitive Advantage:
| Our product features: | Our Services Guarantee: |
| 1) Competitive price | 1) Prompt respond (Reply with 24 hours) |
| 2) Good quality | 2) Free Samples (Customer pay for the delivery cost) |
| 3) Professional Packaging, | 3) Registration support. |
| 4) Produce according to Customers’ instruction | 4) Photos/videos are available during production. |
| 5) None delay shipment | 5) Loading inspection, and send loading photos before shipment.
|
The installment introduction:
1. First, Confirm the pulse valve in good condition and then
installed
2. Pulse valve will be installed directly the outer wall of flange
of gas manifold. The spray pipe across the gas manifold. According
to the drawing and manual, the pulse valve matching appropriate
spray pipe and installation. To avoid the valve install in the air
manifold bottom. If the pulse valve matched trachea and connector,
the connector will be used for sealing purpose only. It can not as
structural support components. It can not rely on the straight
connector fixed spray torch and package. The spray pipe and air
manifold must be fixed independent.
3. To tighten the hard nut, the maximum torque of 20 N*m.Tighten
the trachea, torsion of 20 N*m.
4. The connection control wire needs connect of every electric
control valve seat. Pay attention to the line adown to prevent rain
waterproof. Or through the joint and nylon pipe, it will connect
the pulse valve and electromagnetic assembly boxes of nylon pipe
connection.
5. To ensure that provide compressed air clean and dry. The air
manifold system provides moderate pressure and check for leaks
installation. ( it can brush on soap and water, check whether the
interface is bubble). Pressure was carried out on the air bag
inflated (pressure of the valve is around 0.03 ~ 0. 86 mpa),
recommend for air pressure 0.8 mpa maximum
6. Testing the pulse valve blowing, listening all the pilot valve
whether it is normal operation and whether the pulse blowing sound
is clear.
