Designed for safety and compliance
Verify your test tool works without unnecessary exposure to shock
and arc flash. Make the process easy by using the PRV240FS Proving
unit. Verifying that your T6 electrical tester is working properly
reduces the need for personal protective equipment (PPE) when a
known voltage source is not available for verification before tests
are performed. (PPE is still needed for absence of voltage testing
when appropriate).
On the PRV240FS, a single switch and a set of LEDs indicate
functionality of both standard AC and DC measurements with test
leads, and FieldSense, “no-test-lead” voltage measurement
capability. This unit is a simple-to-use solution for complying
with verification procedures of your test tools.
The PRV240FS also provides AC and DC voltages for all high
impedance instruments in your toolbox. When paired with the
included TPAK magnetic hanging strip and the long battery life,
including this proving unit in your toolbox is an easy decision.
The PRV240FS will last for 2000 tests per set of four AA batteries,
with a 10-second test average.
“Test Before Touch”
Fluke’s PRV240FS allows you to “Test Before Touch” (TBT), which
involves testing your T6 against a known live source before, and
after, the actual measurement. This sequence verifies that your
test tool is operating properly during the actual measurement.
Voltage is sourced through a central hub designed to test the T6
FieldSense open fork, as well as through recessed contacts that are
activated when test probes are inserted to avoid accidental
contact. The PRV240FS has been tested and includes a IEC61010-1,
IEC61010-2-030 safety rating.
