BWD XWD1 Cycloidal Gear Motor Speed Reducer Gearbox With 380V AC
Motor Gear Box Reducer
Description :
Cycloid reducer is a novel transmission device that applies the
principle of planetary transmission and adopts the meshing of
cycloid pin teeth. The entire transmission device of the cycloid
reducer can be divided into three parts: the input part, the
deceleration part, and the output part.
The cycloidal pinwheel reducer adopts the principle of cycloid
pin-tooth meshing and planetary transmission, so it is usually
called a planetary cycloid reducer. The planetary cycloidal
pinwheel reducer can be widely used in petroleum, environmental
protection, chemical industry, cement, transportation, Textile,
pharmaceutical, food, printing, hoisting, mining, metallurgy,
construction, power generation and other industries, as a driving
or deceleration device, the machine is divided into horizontal,
vertical, biaxial and direct-connected assembly methods
Perfect for the machinery and equipment of following industry:
• Power Plant Equipment
• Metallurgical Industry
• Metal Forming Machinery
• Petrochemical Industry & Mining Machine
• Hoisting Machinery
• Construction Industry
• Environmental Protection Industry
• Cable Industry
• Food Machinery
Cycloidal gear reducer Feature
• Single stage drive with reduction ratio 1:87, high effciency.
• Input shaft and ourput shaft are in the same axis, so it's
compact in structure. .
• Cycloid gear with high overlap coefficient, steady the machine
and lower the noise.
• The reducer is made by bearing steel, it's has a long sevice
life.
Conditions of cyclodial gear reducer use
1. The cycloidal pinwheel reducer is allowed to be used in the
occasion of continuous working system, and it is allowed to run in
both forward and reverse directions at the same time. Some models
of cycloid reducer only allow one-way rotation. 2. The rated speed
of the input shaft is 1500 rpm. When the input power is greater
than 18.5 kW, it is recommended to use a 960 rpm 6-pole motor. 3.
The working position of the horizontally installed cycloid reducer
is the horizontal position. The maximum horizontal inclination
angle during installation is generally less than 15°. When it
exceeds 15°, other measures should be taken to ensure sufficient
lubrication and prevent oil leakage. 4. The output shaft of the
cycloid reducer cannot be subjected to large axial force and radial
force, and other measures must be taken when there is a large axial
force and radial force.
Product Parameters
| stage number | one-stage two-stage |
| housing material | iron casting |
| hardness of tooth surface | HRC58-62 |
| Installation type | horizontal or vertical |
| color | Customer requirements |
| bearing | NSK NAK,FAG HRB.etc. |
| Ratio | 9-7569 |
Each reducer needs to be airtight tested before spraying to
minimize the incidence of oilleakage and air leakage. The long life
of the packaged Fanbao reducer is good, thequality is more
intimate, and the customer is more assured.
High quality cycloldal wheel
High-quality bearing steel with excellent fire treatment, high
strength, longrolling contact friction at contact parts
Boutique output shaft
Workshop :
