AA4C Portable movable 3D wheel alignment for both car & truck 3
camera technology
Introduction:
1.Use three cameras technology to measure.
2.Can measure passenger car, light truck, heavy truck, trailer and
bus.
3.Use special calibration technology. Distance from center camera
to the ground is only 10cm, which realize the real-time measurement
near the targets, enhance the target’s definition and also increase
the measurement stability and accuracy. Do not affect left and
right camera column’s communication, solve the traditional
measurement trouble that has to measure far away the vehicle.
4.Use unique technology to solve light interference problem when
measure outdoors. Outdoor real-time measurement can be realized.
5.Can lock the camera and target coordinate system function, so
operator can move camera stand columns or targets based on working
place situation during measurement, do not affect measurement data.
6.High precise plane algorithm of vehicle body can solve the
measurement problem when the measured vehicle is on the cambered
road.
7.Camera column height is only 68cm, light with small volume that
can hang on the mobile service vehicle easily, do not need trolley
and cabinet.
8.Model Y 7’’ screens on the camera column can display equipment
working situation, network situation and measurement data, also can
assist after-sale service person to check and solve problems
through remote-controlled way.
9.Camera and computer can work through battery, working time is 8
hours, equipped with model W wireless screens, which solve the
power supply trouble when work outdoors.
10.Multi-angle LED light board design can make sure the target’s
reflection is enough whatever the distance from camera to the
targets is far or near, make sure the camera’s recognition do not
have tolerance due to distance and sunlight interference.
11.Operator can select to start to measure from the front of the
vehicle or the back of the vehicle based on working place and
vehicle situation.
12.Our aligner can make real-time measurement and adjustment for
double directions truck at a time. Measurement data is accurate and
stable.
13.Pointer targets: pointer targets can calculate vehicle’s
geometric center line position accurately.
14.Measurement mode: static measurements, dynamic measurements.
15.Three point clamps do not need rim compensation.
