ROLL BOND EVAPORATOR
1.Channel tolerances
a)Rolling:±1.5%
b)Out of square:±4.7%
c)Camber:±0.4%
d)Channel widths:+1/0 for longitudinal channels
2.Corner radius of channels: +2/0 for transverse channels R5 for
inside and R15 for outside
3.Embossing:Nothing
4.Leakage pressure test: Maximun 0.9Mpa
5.Distortion pressure test:Maximun 0.9MPa
6.Burst pressur:Minimun2.55MPa
7.Internal volume: xxx cm3 ± 8%( xxx cm 3~ xxx cm3)(For panel) (Calculated)
X= xx cm 3( xx cm3~ xx cm )(Including tubes)
8.Height of burr:Max.0.3mm
9.End of tubes are sealed by rubber cap or plug
10.TRC supplies ROLL-BOND panels filled up with dry air (Intial
pressure 0.3MPa(2kg/cm2.G))
11.Finish:Nothing
12.Internal residue
1)Moisture residue: max.5mg/100cm3
2)Soluble residue: max.10mg/100cm3
3)Oil residue: max.10mg/100cm
4)Chlorine residue: max.5V.ppm
